Read Panasonic PT-MZ16K / PT-MZ13K / PT-MZ10K (serv.man2) Service Manual online
INF-15
SECTION 1 SERVICE INFORMATION
<MZ16K/MZ13K/MZ10K>
4. FLICKER ADJUST
• Perform the flicker adjustment. ( Refer to "SECTION 3 Adjustment")
* Take this adjustment after replacing the optical block or A-PCB.
5. POWER OFF MESSAGE
• Setting of the shutter function with standby operation
- SHUTTER KEEP: When pushing the standby key while the shutter mode is on, the projector keeps the shutter mode on
and sets into standby mode.
- SHUTTER OPEN: When pushing the standby key while the shutter mode is on, the projector opens the shutter and displays
the "Power OFF confirmation message". (Default)
* This projector does not provide the mechanical shutter but it operates the same function.
6. ERROR OSD
• Enables to display the error information of the LIGHT indicators on the screen (It is useful when using the projector with rear
projection mode)
- ON : "LD1/LD2 ERROR" is displayed on the screen if the lighting error occurs. (It will disappear when any of the control
buttons is pressed.)
- OFF : No message is displayed on the screen if the lighting error occurs. (Default)
7. MODEL
• Setting up the model no. of the projector. (Refer to "SECTION 3 Adjustment")
* Take this setting after replacing the A-PCB. The setting will be apply after turning on the Main sw. It is not necessary if the
EEPROM data can be transferred from the original PCB.
8. LIGHT RUNTIME RESET
• Reset the runtime of the LD unit after replacing the LD unit. The resetting will be apply after turning on the Main sw. (Refer to
"SECTION 3 Adjustment")
- LD1-1 : Resets the runtime of LD1-1 unit.
- LD1-2 : Resets the runtime of LD1-2 unit.
- LD2-1 : Resets the runtime of LD2-1 unit.
9. PANEL TYPE SETTING
• Setting up the LCD panel type (L-Type or R-Type). ( Refer to "SECTION 3 Adjustment")
10. RGB PIXEL ADJUST
• Adjusts the convergence. Each pixel cab be moved +- 2 dots vertically and horizontally.( Refer to "SECTION 3 Adjustment")
11. GHOST FB CALIBRATION
• Performs the panel ghost feedback calibration.( Refer to "SECTION 3 Adjustment")
12. CLOG SENSOR CALIBRATION
• Calibrates the clog sensor circuit. ( Refer to "SECTION 3 Adjustment")
13. MUTE TIME OFFSET
• Setting up the black mute time expansion.
If the noise appears at input signal switching, etc., this setting can be invisible it to expand the mute time.
- DISABLE: Default
- 0.5s: expand the mute period in 0.5 second.
|
- 5.0 S: Expand the mute period in 5.0 seconds.
Click on the first or last page to see other PT-MZ16K / PT-MZ13K / PT-MZ10K (serv.man2) service manuals if exist.