Read Panasonic DP-2000 / DP-2500 / DP-3000 Service Manual online
111
C. Updating the Firmware (Control Panel) using the Master Firmware Card (2 MB or higher)
1. Turn the Power Switch to the OFF (O) position.
2. Remove the Control Panel Assembly (See Sect. 2-2-2 and 2-2-3).
3. Install the Master Firmware (Control Panel) Card into the PNL1 PCB (19120).
4. While holding down the Energy Saver key, turn the Power Switch to the ON (I) position. Keep
2. Remove the Control Panel Assembly (See Sect. 2-2-2 and 2-2-3).
3. Install the Master Firmware (Control Panel) Card into the PNL1 PCB (19120).
4. While holding down the Energy Saver key, turn the Power Switch to the ON (I) position. Keep
holding the Energy Saver key for approximately 10 sec.
5. Upon releasing the key, the firmware is copied into the machine.
6. After the update is completed, the machine reboots itself and returns to standby.
7. Turn the Power Switch to the OFF (O) position.
8. Remove the Master Firmware Card from the PNL1 PCB (19120).
9. Re-install the Control Panel Assembly.
6. After the update is completed, the machine reboots itself and returns to standby.
7. Turn the Power Switch to the OFF (O) position.
8. Remove the Master Firmware Card from the PNL1 PCB (19120).
9. Re-install the Control Panel Assembly.
10. Turn the Power Switch to the ON (I) position.
11. Perform the Copy Service Mode F9-02-01 (Control Panel) and verify the Control Panel firmware
version.
D. When the G3B PCB (2nd G3 Fax Communication Option) is installed
Follow the instructions included in the Firmware Update Kit (E-406053) User’s Guide.
E. When EP PC Board (PDL Option) is installed
Install a Flash Memory Card (4 MB or higher) into the machine.
F. When the LAN PC Board (Option) is installed
a. Follow the instructions included in the Firmware Update Kit User’s Guide.
Click on the first or last page to see other DP-2000 / DP-2500 / DP-3000 service manuals if exist.