FZ-A1BDAAXXM, FZ-A1BDAAEE9, FZ-A1BDAAZE9 - Panasonic PC Service Manual (repair manual). Page 47

■ Connection of  Media FPC, and attachment of Media PCB

■ Attachment of Media FPC

1. Insert the Media FPC into the Media PCB connecter, and then 
    close the connecter.
2. Put 1pcs scraps of paper at the bottom of the FPC.
3. Position the Touch PCB on the LCD Module / Upper Case Ass'y.

7. Take the spray gun to blow dust away in the camera hole on 
    the LCD.
8. Remove 2M Camera protective film.

Camera hole

Camera Protective Film

4. Tighten screws*2
    

Note: 

5. Extract pieces of paper.

6. Paste 1pcs Acetate Tape on the Media PCB connecter.

    Note: Paste the acetate Tape toward the cable 

with covering the connecter.

*Notice <Screw tightening torque>

Screw<N6> = 0.165 ± 0.01N·m (1.65 ± 0.1kgf·cm)
<Screw tightening order>
Screw<N6> = 1 - 2

Key point 

Screw<N6>

1

Screw<N6>

2

The screws are not waterproof with no color on its surface. 
Tighten the screw vertically to the bottom once a time, 
aligning with the screw hole. 
Do not repeatedly perform the preceding operation.

1. Remove 2pcs Solder Mask Tape here.
2. Take Media FPC. 
    Insert the LCD Module Cable into the Media FPC connector, 
    close the connector, and then paste 1pcs Tape on the connector. 
    

Note:

3. Remove the FPC adhesive*2 as shown in the figure. 
    Position the FPC on the LCD Module / Upper Case Ass'y.
4. Insert the Media FPC into the LCD Module connector, close the 
    connector, and then paste 1pcs Tape on the connector.
5. Postion 1pcs Conductive Tape at the place as shown in the figure.

The connector edge must be aligned with 
the positioning line after the connector is 
closed.

Paste the Acetate Tape toward the 
cable with covering the connector.

Position the Conductive Tape 
according to the edge of the 
transverse Conductive Tape 
and the positioning line of the 
LCD Module / Upper Case Ass'y.

LCD Module connector

Align the connector edge with the positioning line after 
the connector is closed. 

7-19