KX-UDS124CE - Panasonic PBX Service Manual (repair manual). Page 13

13

Unpack the box and check the items below:

                 *1  All voice channels are occupied.

• Connect the SIP-CSs to the LAN only after completing network settings. For details about network settings.
• When connecting a SIP-CS to the LAN, connect it to a switching hub.

• Use an Ethernet straight cable with an RJ45 connector to connect the SIP-CS to a switching hub. 

The cable should be a 10BASE-T/100BASE-TX CAT 5 (Category 5) or higher cable, and the diameter of the cable must be 6.5
mm or less.

• It is possible to connect the SIP-CS to the LAN while registering the SIP-CS to the SIP server.

1. Connect the cable to the SIP-CS.

SIP Cell Station

1

Screws

2

Washers

2

Green Operation

• OFF: Power Off/CS Software downloading
• Green ON: Stand-by (no active calls)
• Slow Green Flashing: Talk (active calls)
• Moderate Green Flashing: Busy*1
• Red ON: Fault
• Slow red flashing: Out of Service/Starting up (data link establishment 

→ air synchronisation)

• Moderate red flashing: Starting up (power on 

→ data link establishment)

• Amber ON: Stand-by (unstable synchronisation [no active calls])
• Slow amber flashing: Talk (unstable synchronisation [active calls])
• Moderate amber flashing: Busy*1 (unstable synchronisation)

LED flashing patterns are as follows:

• Slow Flashing: 60 times per minute
• Moderate Flashing: 120 times per minute