Read Panasonic UB-5335 / UB-5835 (serv.man2) Service Manual online
16
4.4.
Installation of Wall Hanging Fittings
4.4.1.
Necessary Tools and Parts
The way of hanging the Panaboard depends largely on the structure of the wall. Consult the building manager, the managing engi-
neer, or the designer in advance, whether the structure of the wall is suitable for hanging the heavy system to the wall. For safety,
consult the selection of attachment bolt (sold on the open market) and the construction method sufficiently before attachment.
neer, or the designer in advance, whether the structure of the wall is suitable for hanging the heavy system to the wall. For safety,
consult the selection of attachment bolt (sold on the open market) and the construction method sufficiently before attachment.
(1) Tools necessary for assembly
Phillips screwdriver
Drill
Measuring tape
Level
Dust pump
Hammer
Torque driver (*1 The torque needs to be specified)
Phillips screwdriver
Drill
Measuring tape
Level
Dust pump
Hammer
Torque driver (*1 The torque needs to be specified)
Note: *1
The torque specification range has a limit. Use an appropriate torque driver.
(Recommended tightening torque: 5.2 N m [53 kgf cm]
(Recommended tightening torque: 5.2 N m [53 kgf cm]
(2) Parts required for wall hanging construction
Anchors: 4 pcs
M6 bolts: 4 pcs
Flat washers: 4 pcs
Spring washers: 4 pcs
Anchors: 4 pcs
M6 bolts: 4 pcs
Flat washers: 4 pcs
Spring washers: 4 pcs
Note:
Specified pulling strength of 5 times or more is required per anchor.
The anchor bolt M6 is used for hanging the Panaboard on the wall.
(Specified pulling strength = 196 N [20 kgf] or more)
The anchor bolt M6 is used for hanging the Panaboard on the wall.
(Specified pulling strength = 196 N [20 kgf] or more)
4.4.2.
Request on Construction
4.4.2.1.
Safety Notice on Construction
When attaching the Panaboard, read the following instructions carefully so that no accidents occur.
- Make sure that safety control is secured so as to secure safe and secure operation.
- When the Panaboard shape is changed or is damaged by shock at transportation or at installation, do not perform installation as
- Make sure that safety control is secured so as to secure safe and secure operation.
- When the Panaboard shape is changed or is damaged by shock at transportation or at installation, do not perform installation as
it may fall.
4.4.2.2.
Installation Surface
• Do not attach the Panaboard to a wall not made of plasterboard or plywood that is the major construction section (concrete of
120 mm or more) since its strength is weak. If it is to be inevitably attached, provide sufficient reinforcement (securing five times
or more strength of specified pulling strength of the anchor).
or more strength of specified pulling strength of the anchor).
Click on the first or last page to see other UB-5335 / UB-5835 (serv.man2) service manuals if exist.