Read Panasonic KV-S5055C (serv.man2) Service Manual online
112
U23 (Double-feed
error)
error)
1C
00
xx
00 1. Document quality is out of spec.
on this scanner.
1. Set the correct documents on the Hopper
according to this scanner specification.
according to this scanner specification.
Note: Refer to Sec.2.
2. Rollers (Paper Feed,
Separation, DFP) are not
assembled, properly.
Separation, DFP) are not
assembled, properly.
1. Reassemble the rollers.
3. Rollers (Paper Feed,
Separation, DFP) are dirty.
Separation, DFP) are dirty.
1. Clean the rollers.
2. Clear counter for cleaning roller to zero with
the above service utility.
2. Clear counter for cleaning roller to zero with
the above service utility.
4. Rollers have reached their life
expectancy.
expectancy.
1. Replace the Paper Feed, Separation,
and DFP Rollers after checking each
roller configuration and Scanner Counter
of Service Utility software.
2. Clear counter for replacing roller to zero with
the above service utility.
and DFP Rollers after checking each
roller configuration and Scanner Counter
of Service Utility software.
2. Clear counter for replacing roller to zero with
the above service utility.
5. Double Feed Detector (G) does
not work, properly.
not work, properly.
1. Execute Double Feed test in Sec. 9.3.7 to
adjust "Send Level” for Double Feed
Detectors.
2. Execute Double Feed test in Sec. 9.3.6 to
check the detector condition.
3. Check whether the Double Feed Detector is
aligned property.
4. Check the following connection and
soldering condition on each connector.
adjust "Send Level” for Double Feed
Detectors.
2. Execute Double Feed test in Sec. 9.3.6 to
check the detector condition.
3. Check whether the Double Feed Detector is
aligned property.
4. Check the following connection and
soldering condition on each connector.
a. CN2011 (USS / WAITING SENSOR
Board) to CN3009 (BENT RELAY Board)
b. CN3005 (BENT RELAY) to CN2007
(USS RELAY Board)
c. CN2006 (USS RELAY Board) to CN1008
(CONTROL Board)
(CONTROL Board)
5. Check the following parts' soldering condition
to repair it.
to repair it.
a. CONTROL Board
IC0006-43rd pin
IC0015-21,23,24, and 27th pins)
b. USS RELAY Board
IC2008-3, 15, 18, 20, 22, 24, and 27th pins
Q2001 to Q2008 surrounding circuit.
IC0006-43rd pin
IC0015-21,23,24, and 27th pins)
b. USS RELAY Board
IC2008-3, 15, 18, 20, 22, 24, and 27th pins
Q2001 to Q2008 surrounding circuit.
6. Check the following signals
a. DC 24V signal (CN2006-5th pin)
b. JS_CLK (CN2006 9th pin)
b. JS_CLK (CN2006 9th pin)
→ 300 kHz
c. USS / WAITING SENSOR USS+
(CN2011-7th pin) and
USS-(CN2011-8th pin)
USS-(CN2011-8th pin)
→ See Fig. 7.
7. Replace faulty parts or boards.
Error Code
Possible Cause
Check Point
Remarks
Classified Code ST1 ST2 ST3 ST4
Click on the first or last page to see other KV-S5055C (serv.man2) service manuals if exist.