Read Panasonic NC-PF30PV Service Manual online
- 26 -
NC-PF30PV
2.27. Recheck
After assembly please recheck water leak, insulation resistance and operation, those are usual or unusual.
INSULATION RESISTER
: Measure by 500VDC insulation meter, the result should be more than 2 MΩ.
(Measure between 2 pins of plug and screw).
INSULATION RESISTANCE : Should stand at 1000VAC in 1min. (Measure Location is same as INSULATION
RESISTER).
CURRENT CHECK
: Thermo pot performance test mode (P.2) and operation is usual or unusual.
3 Production No. Position
Production No. is located at Bottom Plate.
4 Body Efficiency Check
Caution
For this test, please careful hot water.
4.1. Keep Warm Temperature Checking
(If Specify 98 Keep Warm)
1. Pour water into the Container and change to boiling
state (be sure to change to boiling state).
2. When keep warm LED is lighted, Check temperature
in 1 hr. later.
Allowance : 90ºC~100ºC (Should not be continuous boiling)
LCD Display : 98
4.2. Amount of Pouring-Out Water
Checking
4.2.1. Electric pump method
1. Pour water into the Container and change to keep
warm state.
2. Measure amount of pouring-out water after change
to keep warm state 1 hr..
3. Press POUR OUT pad and measure amount of
pouring-out water (measure since water starts to
rinse for 5 seconds).
Allowance : 180 ml. up
4.2.2. Air pump method
1. Follow 1
st
and 2
nd
section of 7.2.1
2. Push on Supporting Plate to pump water for once
and measure amount of pouring-out water
Allowance : Amount of water should be more than 180 ml.
4.3. Boiling Time Test (Keep Warm at 98)
1. Pour water into Container and press LONG BOIL/
REBOIL pad (Long Boil/Reboil LED will be blink)
then set it to Long Boil mode.
2. After LCD monitor displays 100, please measure
time until Keep Warm LED is going to be lighted.
Allowance : Long Boil time is approx. 6~9 min.
4.4. Boiling Time When Set Long Boil
State and 98 Keep Warm
1. Poured limited water into Container and press
Long Boil to No-Chlorine state (Long Boil/Reboil
LED will be Lighted).
2. Measure time taken when LCD monitor display 100
until Keep Warm LED is going to be lighted
Allowance : Long Boil time is approx. 6~9 min.
4.5. Cleaning Time Checking (Clean with
Citric Acid)
1. Pour limited water into container and set to boiling
state.
2. Press SELECT pad 3 seconds up until LCD display
change to washing mark.
3. Measure time taken until keepwarm LED and
washing mark blink together.
Allowance : Time for cleaning with citric acid apporx.
15~18 min.
Production Date
Click on the first or last page to see other NC-PF30PV service manuals if exist.