Read Panasonic NC-EG4000WTS / NC-EG3000WTS (serv.man2) Service Manual Simplified online
19
Point in reassembling
• When reassembling the pouring spout, insert the dowel of
container comp. into the 2 long ribs. (refer to “Knob” in below
diagram)
diagram)
• The containner packing shall closely contact the container
flange without twisting or distortion.
6.9.
Name B (Decorative panel)
1. Remove the name B panel by picking with a bladed
screwdriver or a pin at point “A” .
Point in reassembling
• Affix name A in the direction of the arrow starting from point
A
6.10. Peg Frame
1. Remove the bottom ring upward using a bladed screw-
driver or the like.
2. Remove the self-tapping screw.
3. Insert the bladed screwdriver between rib of the peg
3. Insert the bladed screwdriver between rib of the peg
frame and rib of the body. Then turn the bladed screw-
driver to the right hand direction and push angle plate
sharply to release it.
driver to the right hand direction and push angle plate
sharply to release it.
Point in reassembling
• When the body or the bottom ring is replaced, apply a friction
reducing agent. It does not turn smoothly if the volume of the
friction deducing agent is insufficient.
friction deducing agent is insufficient.
6.11. Name A
1. Push out transparent portion of water supply and gauge
cover from inside the body with the thumb.
Click on the first or last page to see other NC-EG4000WTS / NC-EG3000WTS (serv.man2) service manuals if exist.