Read Panasonic NC-DG3000WTS (serv.man2) Service Manual Simplified online
19
Point in reassembling
• When inserting the lead wire E comp. into the control unit B
(for display panel), insert it toward the direction shown in dia-
gram of the previous figure.
gram of the previous figure.
6.7.
Insulation panel A comp.
1. Remove Insulation panel A comp., from Container comp.
(Directly remove upward while Thermistor comp., Ther-
mal fuse comp. and Lead wire D comp., are attached.)
mal fuse comp. and Lead wire D comp., are attached.)
Point when working
• Be careful not to scratch Insulation panel A comp., (Vacuum
state cannot be maintained.)
Point when assembling
• Let the connection of Insulation panel A comp., (A point) fit
with the Rib of holder B.
6.8.
Thermal Fuse comp. and
Thermistor comp.
Thermistor comp.
1. Remove the screws from the thermal insulator cover.
2. Remove the lead wires from the heater terminals.
3. Remove the thermal insulator cover from the body.
4. Remove the non-flammable tube B.
5. Remove the thermal fuse comp. from the thermal insula-
2. Remove the lead wires from the heater terminals.
3. Remove the thermal insulator cover from the body.
4. Remove the non-flammable tube B.
5. Remove the thermal fuse comp. from the thermal insula-
tor cover.
6. Remove the holding spring A of the thermistor comp. from
the thermal insulator cover.
7. Before removing the thermistor comp. from holding spring
A, turn it 90 degrees.
Click on the first or last page to see other NC-DG3000WTS (serv.man2) service manuals if exist.