Read Panasonic MC-E6003 / MC-E6003K / MC-E6001 / MC-E6001K Service Manual online
Fig. 15
Power
control circuit
Motor
cover
Rear filter
Fig. 17
Main switch
Fuse
Main switch
Fig. 18
Fig. 16
Remove
connections
3.6. POWER CONTROL CIRCUIT
9
1. Remove upper body as explained previously in paragraph
3.1 Motor, points 1-2.
2. Remove connections from contact spring and take out cord
reel assembly and motor unit.
3. Take out rear filter and remove power control circuit from
its support.(Fig. 15)
3.7. FUSE (10A)
1. Remove upper body as explained previously in paragraph
3.1 Motor, points 1-2.
2. Remove fuse lead wire (provided with quick-connect
terminal) from the main switch tab and contact spring.
(Fig.17)
(Fig.17)
3. Replace the fuse unit with a new one and connect
according to the schematic diagram. Note: Make sure
switches SW1 / SW2 are correctly assembled as indicated
in figure 7.
switches SW1 / SW2 are correctly assembled as indicated
in figure 7.
4. Connect the lead wires according to the schematic diagram
and reassemble upper body and remaining parts in the
reverse order.
reverse order.
Note: Make sure the lead wires are correctly positioned
to avoid pinching them between parts.
to avoid pinching them between parts.
3.8. MAIN SWITCH
1. Remove upper body as explained previously in paragraph
3.1 Motor, point 1-2.
2. Remove main switch and disconnect lead wires (provided
with quick-connect terminal) from the main switch tabs.
(Fig.18)
(Fig.18)
3. Replace main switch with a new. Connect the lead wires to
the switch tabs and reinstall it making sure the switch
button is correctly positioned.
Note: Make sure switches SW1 / SW2 are correctly
assembled as indicated in figure 7.
button is correctly positioned.
Note: Make sure switches SW1 / SW2 are correctly
assembled as indicated in figure 7.
4. Note: Make sure the lead wires are correctly positioned
to avoid pinching them between parts.
4. Remove the lead wires provided with quick-connect
terminal from the PCB and replace power control circuit
with a new one. (Fig.16)
with a new one. (Fig.16)
5. Connect the lead wires (provided with quick-connect
terminal) to the new PCB tabs as indicated on the
schematic diagram and reinstall power control circuit
in its support.
schematic diagram and reinstall power control circuit
in its support.
Note: Make sure the lead wires are correctly
positioned in the motor cover slots.
positioned in the motor cover slots.
6. Place back the motor unit and cord reel assembly.
Connect the lead wires according to the schematic
diagram and reassemble upper body and remaining
parts in the reverse order.
diagram and reassemble upper body and remaining
parts in the reverse order.
MC-E6003 / MC-E6003K / MC-E6001 / MC-E6001K
Click on the first or last page to see other MC-E6003 / MC-E6003K / MC-E6001 / MC-E6001K service manuals if exist.