Read Panasonic MC-E6003 / MC-E6003K / MC-E6001 / MC-E6001K Service Manual online
Fig. 8
Screw
Motor
Carbon bruch
Fig. 9
Cord stopper
Screw
Fig. 10
Cord reel
support
Cord reel
unit
Screw
3.2. CARBON BRUSHES
7
Note: Replace both carbon brushes at the same time.
1. Take out motor unit and remove motor cover as explained
previously in paragraph 3.1 Motor, points 1-4.
2. Disconnect lead wires (provided with quick-connect
terminal) from the motor tabs.
3. Remove the screw from the carbon brush holder and
take it out. (Fig.8)
3.3. CORD REEL UNIT
1. Remove upper body and take out cord reel ass`y as
explained previously in paragraph 3.1 Motor, points 1-3.
2. Remove the screw from the cord stopper to release power
supply cord. (Fig. 9)
3. Press the brake lever and unwind the power supply cord
two times to release the cord reel spring efficiency.
4. Detach cord reel unit and cord reel support by removing
the screw. (Fig. 10)
5. Replace the cord reel unit with a new one and reassemble
with the cord reel support refastening the screw.
Note: Wind up the power supply cord 2 extra times, as
indicated on the spring plate, to maintain the spring
efficiency. Finally, place the cord stopper and refasten
the screw.
indicated on the spring plate, to maintain the spring
efficiency. Finally, place the cord stopper and refasten
the screw.
6. Connect the lead wires according to the schematic
diagram.
7. Reinstall cord reel ass’y into place and reassemble the
remaining parts in the reverse order.
4. Replace the carbon brush unit with a new one and reinstall
it refastening with the screw.
5. Connect the lead wires according to the schematic diagram
and reassemble the motor unit.
6. Re-install motor unit, cord reel ass’y into their lodging and
reassemble the remaining parts in the reverse order.
MC-E6003 / MC-E6003K / MC-E6001 / MC-E6001K
Click on the first or last page to see other MC-E6003 / MC-E6003K / MC-E6001 / MC-E6001K service manuals if exist.