Read Panasonic MC-E6003 / MC-E6003K / MC-E6001 / MC-E6001K Service Manual online
Fig. 11
Stopper
Fig. 13
Fig. 12
Rail base
Blue wire
Brown wire
Fig. 14
Cord reel
support
Brake lever unit
Spring
3.4. POWER SUPPLY CORD
8
1. To replace the power supply cord, take out cord reel ass’y
and disassemble it as explained previously in paragraph
3.3 Cord reel unit, points 1-4.
3.3 Cord reel unit, points 1-4.
2. Unwind the power supply cord from the cord reel unit.
3. Press and release the stopper on the cord reel and lift the
rail base by pushing the lower end. (Fig. 11)
3.5. BRAKE LEVER UNIT
1. To replace the brake lever unit, take out cord reel ass'y and
disassemble it as explained in paragraph 3.3 Cord reel
unit, points 1-4.
unit, points 1-4.
2. Remove the spring and brake lever unit from cord reel
support and replace with a new one. (Fig.14)
3. Re-install the brake lever unit and spring and reassemble
cord reel unit and cord reel support.
Note: Wind up the power supply cord 2 extra times, as
indicated on the spring plate, to maintain the spring
efficiency. Finally, place the cord stopper and refasten
the screw.
Note: Wind up the power supply cord 2 extra times, as
indicated on the spring plate, to maintain the spring
efficiency. Finally, place the cord stopper and refasten
the screw.
4. Reinstall cord reel ass'y and connect the lead wires
according to the schematic diagram. Then reassemble
upper body and remaining parts in the reverse order.
upper body and remaining parts in the reverse order.
4. Disconnect the power supply cord from the rail base and
replace with a new one.
Note: Observe the colour of the lead wires from the
power supply cord before reinstalling the new one.
(Fig.12)
power supply cord before reinstalling the new one.
(Fig.12)
5. Insert the rail base through the cord reel slot. (Fig.13)
Note: Put grease on the rail base before assembling
the cord reel support.
the cord reel support.
6. Wind up the power supply cord in the arrow direction as
indicated on the spring plate.
7. Reassemble cord reel unit and cord reel support and
refasten the screw.
Note: Wind up the power supply cord 2 extra times to
maintain spring efficiency. Finally, place the cord
stopper an refasten the screw.
maintain spring efficiency. Finally, place the cord
stopper an refasten the screw.
8. Reinstall cord reel ass’y into place. Connect the lead wires
according to the schematic diagram and reassemble upper
body and remaining parts in the reverse order.
body and remaining parts in the reverse order.
MC-E6003 / MC-E6003K / MC-E6001 / MC-E6001K
Click on the first or last page to see other MC-E6003 / MC-E6003K / MC-E6001 / MC-E6001K service manuals if exist.