UF-490, UF-4000, UF-4100 - Panasonic Fax Service Manual (repair manual). Page 113

Read Panasonic UF-490 / UF-4000 / UF-4100 Service Manual online

113
4.7.
Information Codes Table (For Facsimile)
Fax Information Codes
Code
Mode
Phase
Description of Problem
Cause
001
RCV
COPY
C, D
Leading edge of the recording 
paper fails to reach the Timing 
Sensor.
Recording paper jam.
Timing Sensor abnormal.
007
RCV
COPY
C, D
1.Leading edge of the recording 
paper fails to reach the Paper 
Exit Sensor.
2.Recording paper has not 
completely passed the Paper 
Exit Sensor.
Recording paper jam.
Paper Exit Sensor abnormal.
010
RCV
COPY
B, C
No recording paper. 
No recording paper or paper is not set
properly.
No Paper Sensor is defective.
012
RCV
C, D
The length of the received 
document is over 2 meter (78.7in).
021
STANDBY
RX
COPY
B, C, D Thermistor is abnormal.
Fuser Control is abnormal.
Fan is abnormal.
Defective SC PCB.
Defective Fuser Unit, Power Supply 
Unit.
Defective Fan.
030
XMT
B
Read Point Sensor does not go 
ON within 10 seconds after the 
document starts feeding.
Document is not set properly.
Defective Read Point Sensor.
031
XMT
COPY
C
Transmitting document was longer
than 2 meter (or 78.7 in).
The document may jam.
Defective Read Point Sensor.
041
STANDBY
RX
COPY
B, C, D Out of toner.
No toner.
Defective Toner Sensor.
043
STANDBY
RX
COPY
B, C, D Low toner.
Toner is getting low.
Defective Toner Sensor.
044
RCV
COPY
-
OPC Drum Unit maintenance.
Reached the number of regulation for
printing.
045
STANBY
-
No Toner Cartridge.
Toner cartridge has not been installed.
Defective Toner Sensor 
(Cartridge Sensor).
046
STANDBY
RX
COPY
-
Time to replace Drum Unit.
 
Drum use rate is reached 100%.
(Approx. 12,000 to 20,000 pages)
051
RCV
COPY
-
Motor abnormal.
Connector not properly connected.
Defective Motor.
Defective SC PCB.
054
STANDBY
RX
COPY
-
HSYNC abnormal.
Motor abnormal.
Defective Laser Unit.
061
-
A
ADF Cover is open.
Cover is not firmly closed.
Connectors are not firmly connected.
212
XMT 
RCV
A-E
Interface error occurred between 
the CPU and modem.
Modem is defective. (SC PCB)
Software problem occurred. (SC PCB)
Page of 127
Display

Click on the first or last page to see other UF-490 / UF-4000 / UF-4100 service manuals if exist.