Read Panasonic WV-NP472E Service Manual online
– 5 –
7. Type COPY NP472E.SEQ B: and press ENTER key.
8. Type CD\ and press ENTER key.
9. Type CD EVR and press ENTER key.
10. Type COPY NP472E.EV2 B: and press ENTER key.
11. After completing installation of program, you are ready
to use the E.V.R. adjustment program.
3.3.Setting Up
8
The adjustments should be done with this initial setting,
unless otherwise specified.
unless otherwise specified.
8
The adjustments should be done after 10 minutes warm
up.
up.
4. Adjustment Procedure
8
Refer to the Location of Test Points and Adjusting
Controls on the page 12.
Controls on the page 12.
4.1 Adjustment Procedure-1
(1). Flange-back Adjustment
Test Point:
CN403 (Video Output Connector)
I/F Power Board
Adjust:
Flange-back Adjusting Ring
8
Mount the ALC Lens WV-LA9C3B on the Camera.
8
Set the Radiation Chart 10m away from the Camera.
8
Aim the Camera at the Radiation Chart.
8
Referring to Fig. 4-1, loosen the Flange-back Adjusting
Screw that secure the Flange-back Adjusting Ring.
Screw that secure the Flange-back Adjusting Ring.
8
Adjust the Flange-back Adjusting Ring to obtain best
focal point.
focal point.
Fig. 4-1
(2). Switch Setting
8
Remove the Upper Cover.
8
Set the switch SW3 on the Board to the position as
shown in Fig. 3-3.
8
Set the VP/STD.Camera Selection Switch on the Rear
Panel to STD CAMERA position.
(3). Installing E.V.R. Adjustment Program
8
Make a copy of following necessory files to your comput-
er from original floppy disk of the Remote E.V.R.
Adjustment Kit.
er from original floppy disk of the Remote E.V.R.
Adjustment Kit.
RADJ2.EXE
NP472E.SEQ
NP472E.EV2
(4). Procedure
1. Confirm that the CONFIG.SYS file on your computer
contains DEVICE=ANSI.SYS.
2. Insert floppy disk containing E.V.R.adjustment
program into your floppy drive (for example,drive:A)
and type A:
3. At the prompt, type CD IBMPC and press ENTER key.
4. Type COPY RADJ2.EXE B: and press ENTER key.
5. Type CD\ and press ENTER key.
6. Type CD SEQ and press ENTER key.
8
Tighten the Flange-back Adjusting Screw that secure the
Flange-back Adjusting Ring carefully.
Flange-back Adjusting Ring carefully.
Flange-back
Adjusting Ring & Screw
Adjusting Ring & Screw
ALC Lens
<Rear>
<Front>
Board
SW3
ON
<SW3>
<SW3>
1
2
3
4
Select switch #2 to ON (PAL) position.
#
ON
OFF
1
FIX
2
PAL
NTSC
3
FIX
4
FIX
Fig. 3-3
Click on the first or last page to see other WV-NP472E service manuals if exist.