WV-CU360 - Panasonic Video Monitoring Service Manual (repair manual). Page 5

– 3 –

@2

Pressing this button will activate the housing defroster of
cameras provided with this feature. Pressing it after
pressing the Shift button will turn on the AUX2 button
controlling accessories connected to the cameras or the
system.
The LED next to the button is lit while the defroster or
AUX2 mode is selected.

@3

Pressing this button will activate the housing wiper of
cameras provided with this feature. Pressing it after
pressing the Shift button will turn on the AUX1 button
controlling accessories connected to the cameras or the
system.
The LED next to the button is lit while the wiper or AUX1
mode is selected.

@4

Pressing this button will turn on the camera patrol play
function. Pressing this button while holding down the
Program/Camera setup/Camera function button, will
start to program the camera patrol learning function.

@5

Pressing this button will activate the alarm suspension
mode (alarm input is ignored).
The LED next to the button is lit while alarm suspension
mode is selected.

@6

Pressing this button while the alarm function is activated
will reset the alarm of the system.
Pressing this button after pressing the shift button will
recall the alarm logs (record of alarms activated in the
past).
Select a monitor, and then press this button to display
the alarm logs on the monitor screen. Pressing the but-
ton after pressing the shift button again will cancel the
function. 
The LED next to the button is lit while Alarm Recall
mode is activated.

@7

This button is used to operate the multiscreen monitor
connected to the MULTISCREEN OUT connector of the
Video Multiplexer.
Note: The above operation is not available unless a mul-

tiscreen monitor is selected.

@8

Selects to confirm VTR playback picture for display on
the multiscreen monitor.
The LED next to the button is lit while VTR mode is
selected.

@9

Pressing this button will zoom the camera picture or
VTR playback picture displayed on the multiscreen mon-
itor.
Pressing it after pressing the Shift button moves the
camera sequence one step forward from the step previ-
ously paused on the monitor by pressing the SEQ
PAUSE button (This function is available only to system
units with the sequence pause function).
Pressing this button after pressing the Shift button will
replace the currently selected camera with the next high-
er camera number (This function is available to  Data
Multiplex Unit such as the WJ-MP204).
The LED next to the button is lit while Electronic Zoom
mode is selected.

#0

Pressing this button will freeze the camera picture or
VTR playback picture displayed on the multiscreen mon-
itor.
Pressing it after pressing the Shift button moves the
camera sequence one step backward from the step pre-
viously paused on the monitor by pressing the SEQ
PAUSE button (This function is available only to system
units with the sequence pause function).
Pressing it after pressing the Shift button will replace the
currently selected camera with the next lower camera
number (This function is available to Data Multiplex Unit
such as the WJ-MP204).
The LED next to the button is lit while Still mode is
selected.

#1

Pressing this button will activate Sequence mode. In this
mode, a series of camera pictures is displayed in suc-
cession on the monitor screen for the specified duration.
Pressing it while holding down the Program /Camera
Setup/Camera Function button will stop to program the
camera patrol learning function.
The LED next to the button is lit while Sequence mode is
selected.

#2

This button is used to bring a running sequence on the
selected monitor to a pause. In this mode, a series of
camera pictures is displayed in pause on the monitor
screen for the specified duration. If this button is pressed
while the joystick controller is moved, pan/tilt speed will
decrease.