Read Panasonic WV-CU360 Service Manual online
– 4 –
■
Rear View
DC 9V IN
DATA
MODE
RISK OF ELECTRIC
SHOCK. DO NOT OPEN
SHOCK. DO NOT OPEN
RISQUE DE CHOCS ELECTROUES
NE PAS OUVRIR
0
9
8
7
6
5
4
3
2
1
#6
#7
#5
CONTROLLER No.
#4
#3
Refer to the Operating Instructions of the Data Multiplex Unit
WJ-MP204 for further details.
WJ-MP204 for further details.
NOTE
#6
DC 9V Input Jack
(DC 9V IN)
(DC 9V IN)
Jack for the DC plug of the supplied AC adapter.
#7
Clamper
The clamp fastens the power cord to the AC adapter.
#3
Controller Number switch
(CONTROLLER No.)
(CONTROLLER No.)
This switch is used to set a controller number for the
System Controller to identify it in a system comprising
multiple System Controllers. A system may comprise up
to four controllers.
Note: Keep the DC plug of the supplied AC adapter dis-
System Controller to identify it in a system comprising
multiple System Controllers. A system may comprise up
to four controllers.
Note: Keep the DC plug of the supplied AC adapter dis-
connected from DC 9V Input Jack during controller
number setting.
number setting.
#4
Mode Selection switches
(MODE)
(MODE)
The DIP switches are used to change the internal set-
tings of the System Controller.
tings of the System Controller.
#5
Data Ports
(DATA)
(DATA)
These ports are used to exchange control data with the
WJ-MP204 Data Multiplex Unit via the supplied RS-485
cable.
WJ-MP204 Data Multiplex Unit via the supplied RS-485
cable.
Click on the first or last page to see other WV-CU360 service manuals if exist.