Read JBL ON STAGE III IIIP (serv.man7) EMC - CB Certificate online
Audix Technology (Shenzhen) Co., Ltd. Report No. ACS-E07439 page 34 of 66
9.3. Test Standard
EN 55024: 1998+A1:2001+A2: 2003 (IEC 61000-4-3: 2002+A1: 2002)
(Severity Level: 2 at 3V / m)
9.4. Severity Levels and Performance Criterion
9.4.1. Severity level
Level
Test Field Strength V/m
1.
1
2.
3
3.
10
X Special
9.4.2. Performance
criterion
: A
9.5. EUT Configuration
The configuration of EUT are listed in Section 3.5.
9.6. Operating Condition of EUT
Same as radiated test which is listed in Section 4.6. except the test set up replaced by
Section 9.2.
9.7. Test Procedure
Testing was performed in a Fully anechoic chamber as recommended by IEC 61000-4-3.
The EUT was placed on an 80 cm high non-conductive table located in the area of field
uniformity. The radiating antenna was placed 3m in front of the EUT and Support system,
and dwell time of the radiated interference was controlled by an automated,
computer-controlled system. The signal source was stepped through the applicable
frequency range at a rate no faster than 1％ of the fundamental. The signal was amplitude
modulated 80％ over the frequency range 80 MHz to 1GHz at a level of 3 V/m. The
dwell time was set at 3.0 s. Field presence was monitored during testing via a field probe
placed in close proximity to the EUT. Throughout testing, the EUT was closely monitored
for signs of susceptibility. The test was performed with the antennae oriented in both a
horizontal and vertical polarization.
The EUT was placed on an 80 cm high non-conductive table located in the area of field
uniformity. The radiating antenna was placed 3m in front of the EUT and Support system,
and dwell time of the radiated interference was controlled by an automated,
computer-controlled system. The signal source was stepped through the applicable
frequency range at a rate no faster than 1％ of the fundamental. The signal was amplitude
modulated 80％ over the frequency range 80 MHz to 1GHz at a level of 3 V/m. The
dwell time was set at 3.0 s. Field presence was monitored during testing via a field probe
placed in close proximity to the EUT. Throughout testing, the EUT was closely monitored
for signs of susceptibility. The test was performed with the antennae oriented in both a
horizontal and vertical polarization.
All the scanning conditions are as follows :
Condition of Test
Remarks
----------------------------------------------
----------------------------------
1. Test Fielded Strength
3 V/m (Severity Level 2)
2. Radiated Signal
80% amplitude modulated with a
1kHz sine wave
3. Scanning Frequency
80 - 1000 MHz
4. Sweeping time of radiated
0.0015 decade/s
5. Dwell Time
3.0 Sec.
9.8. Test Results
PASS.
The EUT was tested and all the test results are listed in next page.
The EUT was tested and all the test results are listed in next page.
Click on the first or last page to see other ON STAGE III IIIP (serv.man7) service manuals if exist.