Read JBL ON STAGE III IIIP (serv.man2) EMC - CB Certificate online
<12014238 001 >
Page 51 of 77
National Differences
Clause
Requirement − Test
Result – Remark
Verdict
Australian National Differences according to CB Bulletin No. CB Bulletin No. 109A, December 2005
APPENDIX Australian National Differences according to CB Bulletin No. 109A, December
2005 (AS/NZS 60950.1:2003)
(IEC Publication 60950-1:2001)
P
EXPLANATION FOR ABBREVIATIONS
P=Pass, F=Fail, N=Not applicable. Placed in the column to the right.
Annex ZZ Variations
Between the definitions for "Person, service" and
"Range, rated frequency" insert the following:
"Range, rated frequency" insert the following:
1.2
Potential ignition source
1.2.12.201
Inserted.
P
1.2.12.15
After the definition of 1.2.12.15, add the following:
1.2.12.201 Potential ignition source:
Possible fault which can start a fire if the open-
circuit voltage measured across an interruption or
faulty contact exceeds a value of 50 V (peak) a.c.
or d.c. and the product of the peak value of this
voltage and the measured r.m.s. current under
normal operating conditions exceeds 15 VA.
circuit voltage measured across an interruption or
faulty contact exceeds a value of 50 V (peak) a.c.
or d.c. and the product of the peak value of this
voltage and the measured r.m.s. current under
normal operating conditions exceeds 15 VA.
Such a faulty contact or interruption in an
electrical connection includes those which may
occur in conductive patterns on printed boards.
electrical connection includes those which may
occur in conductive patterns on printed boards.
NOTE 201: An electronic protection circuit may be
used to prevent such a fault from becoming a
potential ignition source.
used to prevent such a fault from becoming a
potential ignition source.
NOTE 202: This definition is from AS/NZS
60065:2003.
60065:2003.
Added.
P
1.5.1
Add the following to the end of first paragraph:
"or the relevant Australian/New Zealand
Standard."
Standard."
Added.
P
1.5.2
Add the following to the end of first and third dash
items:
items:
"or the relevant Australian/New Zealand
Standard."
Standard."
Added and see appendix II for
plug test report.
plug test report.
P
2.1
Delete the Note.
Deleted
P
3.2.3
Delete Note 2.
Deleted
N/A
Modify Table 3B as follows:
Rated current of
equipment A
Nominal
cross-
sectional
area mm
2
AWG or kcmil
(cross-sectional
area in mm
2
)
see note 2
3.2.5
Over 0.2 up to
and including 3
and including 3
0.5
1)
18 [0.8]
Replaced.
N/A
Click on the first or last page to see other ON STAGE III IIIP (serv.man2) service manuals if exist.