Read JBL ON STAGE 400P (serv.man4) EMC - CB Certificate online
IEC 60950-1 (ed.1)
- Page 1 of 8 -
www.nemko.com
Report No. 100711
TRF No. IECEN60950_1C
ATTACHMENT: AUSTRALIAN / NEW ZEALAND DIFFERENCES
Test results according to CB BULLETIN No. 112A, December 2006
Clause
Requirements – Test
Result – Remark
Verdict
ZZ.1 Introduction
This Annex sets out variations between this Standard and IEC 60950-1:2001. These variations indicate
national variations for purposes of the IECEE CB Scheme and will be published in the IECEE CB Bulletin.
These variations are indicated within the body of the Standard.
national variations for purposes of the IECEE CB Scheme and will be published in the IECEE CB Bulletin.
These variations are indicated within the body of the Standard.
ZZ.2 Variations
The variations are as follows:
1.2
Between the definitions for ‘Person, service’ and
‘Range, rated frequency’ insert the following:
‘Range, rated frequency’ insert the following:
POTENTIAL IGNITION SOURCE
1.2.12.201
Considered.
P
1.2.12.15 After the definition 1.2.12.15, add the following:
1.2.12.201
POTENTIAL IGNITION SOURCE:
Possible fault which can start a fire if the open-
circuit voltage measured across an interruption or
faulty contact exceeds a value of 50 V (peak) a.c.
or d.c. and the product of the peak value of this
voltage and the measured r.m.s. current under
normal operating conditions exceeds 15 VA.
Such a faulty contact or interruption in an
electrical connection includes those which may
occur in CONDUCTIVE PATTERNS on PRINTED
BOARDS.
circuit voltage measured across an interruption or
faulty contact exceeds a value of 50 V (peak) a.c.
or d.c. and the product of the peak value of this
voltage and the measured r.m.s. current under
normal operating conditions exceeds 15 VA.
Such a faulty contact or interruption in an
electrical connection includes those which may
occur in CONDUCTIVE PATTERNS on PRINTED
BOARDS.
NOTE 201: An electronic protection circuit may be used
to prevent such a fault from becoming a POTENTIAL
IGNITION SOURCE.
to prevent such a fault from becoming a POTENTIAL
IGNITION SOURCE.
NOTE 202: This definition is from AS/NZS 60065:2003.
Considered. P
1.5.1
Add
the following to the end of first paragraph:
‘or the relevant Australian/New Zealand
Standard’.
Standard’.
Considered.
P
1.5.2
Add
the following to the end of first and third dash
items:
‘or the relevant Australian/New Zealand
Standard’.
Standard’.
Considered.
P
2.1
Delete
the Note
Considered.
P
3.2.3
Delete
Note 2
The equipment is not intended
for permanent connection to the
mains.
for permanent connection to the
mains.
—
Click on the first or last page to see other ON STAGE 400P (serv.man4) service manuals if exist.