Read JBL ON STAGE 400P (serv.man4) EMC - CB Certificate online
IEC 60950-1 (ed.1)
- Page 4 of 8 -
www.nemko.com
Report No. 100711
TRF No. IECEN60950_1C
4.7.201
Parts for which the glow-wire test cannot be
carried out, such as those made of soft or foamy
material, shall meet the requirements specified in
ISO 9772 for category FH-3 material. The glow-
wire test shall not be carried out on parts of
material classified at least FH-3 according to ISO
9772 provided that the sample tested was not
thicker than the relevant part.
carried out, such as those made of soft or foamy
material, shall meet the requirements specified in
ISO 9772 for category FH-3 material. The glow-
wire test shall not be carried out on parts of
material classified at least FH-3 according to ISO
9772 provided that the sample tested was not
thicker than the relevant part.
4.7.201.3 Testing of insulating materials
Parts of insulating material supporting
POTENTIAL IGNITION SOURCES
POTENTIAL IGNITION SOURCES
shall be
subject to the glow-wire test of AS/NZS
60695.2.11 which shall be carried out at 750°C
The test shall also be carried out on other parts of
insulating material which are within a distance of 3
mm of the connection.
60695.2.11 which shall be carried out at 750°C
The test shall also be carried out on other parts of
insulating material which are within a distance of 3
mm of the connection.
NOTE: Contacts in components such as switch contacts
are considered to be connections.
are considered to be connections.
For parts which withstand the glow-wire test but
produce a flame, other parts above the connection
within the envelope of a vertical cylinder having a
diameter of 20 mm and a height of 50 mm shall be
subjected to the needle-flame test. However, parts
shielded by a barrier which meets the needle-
flame test shall not be tested.
The needle-flame test shall be made in
accordance with AS/NZS 4695.2.2 with the
following modifications:
produce a flame, other parts above the connection
within the envelope of a vertical cylinder having a
diameter of 20 mm and a height of 50 mm shall be
subjected to the needle-flame test. However, parts
shielded by a barrier which meets the needle-
flame test shall not be tested.
The needle-flame test shall be made in
accordance with AS/NZS 4695.2.2 with the
following modifications:
All materials have suitable flame
class, no testing required.
class, no testing required.
P
Click on the first or last page to see other ON STAGE 400P (serv.man4) service manuals if exist.