DRIVE AND PLAY (serv.man16) - Harman Kardon Car Audio User Guide / Operation Manual. Page 8

Installing Components

Installing the Control Knob (continued)

2. At the base (below the cable), using the 1.5mm hex key,

loosen (but do not remove) the hex setscrew.

3. To install the Control Knob with adhesive tape, perform the

following steps or skip to step 4:

a. Insert the mounting plate, rotate it 180°, and tighten

the hex setscrew.

b. At the site, wipe the surface and exposed mounting

plate with one of the enclosed alcohol pads. Allow both
to dry.

c.  Remove the protective tape from one side of one of the

enclosed adhesive pads, and press the pad against the
mounting plate.

d.  Remove the remaining protective tape, and press and

hold the Control Knob to its site for 5 seconds.

4. To install the Control Knob with mounting screws, perform

the following steps:

a. At the proposed site, place the mounting plate and

rotate it so that the arrow will point toward the hex 
set-screw at the back of the base after it’s mounted.

b. Holding the mounting plate in position, fasten it to the

surface with three enclosed mounting screws.

c.  Using the mounting plate’s center hole as a template,

drill a hole through the mounting surface and pass the
Control Knob’s cable through the hole.

d. Place the Control Knob on the mounting plate (180°

from its final position), and then rotate it a half-turn to
the final position. Tighten the hex setscrew at the back
of the base.

5. Route the attached cable to the Electronics Enclosure.

Installing the iPod Cable

Route the iPod dock connector cable to the chosen iPod site
(e.g., the center console compartment or the glove box). Be
sure to leave enough cable exposed to make connecting and
disconnecting the iPod easy.

Making the System Connections

With all power off, refer to the Wiring Diagram on page 5 and
make only the power, ground and audio signal connections
that apply to the scheme you have chosen. After verifying all
connections including the iPod, proceed to the next section,
Operating Drive + Play.

OPERATING DRIVE + PLAY

Distraction Warning

Do not connect or disconnect your iPod or program Drive +
Play while driving. Always pull off the road and park in a 
position that you are absolutely sure presents no risk before
browsing your iPod or adjusting the settings on your Drive +
Play. Always obey all traffic laws while driving.

Overview

Press Once to Play Next Track

Press Once to Choose
Highlighted Menu Item

Scroll Right Once to Next Menu Item
Scroll Right and Hold to Jump Forward
In Now Playing, Scroll Right to
Fast Forward

S

croll Left Once to Last Menu Item 

Scroll Left and Hold to Jump Back

In Now Playing, Scroll Left to

Fast Rewind

Press Once to

Jump to Last Screen

Press Once to Stop or

Resume Play of Current Track

Press Once to Play Last Track