Read Harman Kardon DRIVE AND PLAY (serv.man16) User Guide / Operation Manual online
Installing Components
Installing the Electronics Enclosure
At the selected site, install the Electronics Enclosure. Use either
the enclosed cable ties or mounting screws, as shown below.
the enclosed cable ties or mounting screws, as shown below.
Installing the Text Display
1. Temporarily place the Text Display at the proposed site
and check the default viewing angle while adjusting the
pivot arm. If it meets your needs, then skip to step 2.
Otherwise, change the viewing angle as follows:
pivot arm. If it meets your needs, then skip to step 2.
Otherwise, change the viewing angle as follows:
a. Using the 3 mm hex key, loosen the recessed hex screw
(inside the display base) until the pivot arm is free from
the display assembly. The hex screw will remain captive.
the display assembly. The hex screw will remain captive.
b. Select another viewing angle position (middle or top).
Reassemble the parts in reverse order and tighten the
recessed hex screw.
recessed hex screw.
2. At the base, using the 1.5mm hex key, loosen (but do not
remove) the hex setscrew.
3. To install the Text Display with adhesive tape, perform the
following steps or skip to step 4:
a. Insert the mounting plate, rotate it 180°, and tighten
the hex setscrew as shown below.
6 INSTALLATION
Recessed
Hex Screw
Hex Screw
Display
Assembly
Assembly
Display
Base
Base
3mm
Hex Key
Mounting
Plate
Plate
Adhesive
Pad
Pad
Hex Setscrew
Click on the first or last page to see other DRIVE AND PLAY (serv.man16) service manuals if exist.