SOUNDSTICKS III (serv.man2) - Harman Kardon Audio EMC - CB Certificate (repair manual). Page 82

 

 

- Page 4 of 6 - 

 

 

Report No.   158002 

 

 

 

 

Replacement: 
Replace Table 5A. 

 

Class III equipment 

N/A 

Replacement: 
Replace 3rd Item as follows. 

- BASIC INSULATION between the PRIMARY 
CIRCUIT and accessible conductive parts of 
CLASS I or 0I EQUIPMENT; 

Class III equipment 

N/A 

Annex A 
 

Add this Sub-Clause:  
Flammability tests for classifying materials VTM 

Thin sheet materials shall comply with ISO 9773.

Comply with the requirement.

P 

Annex G 

Add the following new note below Table G.1: 
2. In Japan, MAINS TRANSIENT VOLTAGE for 
equipment with a Nominal AC MAINS SUPPLY 
VOLTAGE of 100V is to be decided based on the 
column where Nominal AC MAINS SUPPLY 
VOLTAGE in Table G.1 is 150V. 

Not used. 

N/A 

Annex P 

Add “IEC 61965:2000, Mechanical Safety for 
Cathode Ray Tubes”. 

CRT(s) not used in the equip
ment. 

N/A 

Annex U 

Replace the second paragraph by: 
This annex covers to round winding wires having 
diameters between 0.05 mm and 5.00 mm. 

See main test report. 

N/A 

U.2.1 

Replace the text of this Sub-Clause by: 
The test sample is prepared according to IEC 
60851-5:1996, 4.4.1 (for a twisted pair). The 
sample is then subjected to the test of 5.2.2 of 
this standard, with a test voltage not less than 
twice the appropriate voltage in table 5B (see 
5.2.2) of this standard. However, the minimum 
values shall be as follows: 

- 

for BASIC INSULATION or 
SUPPLEMENTARY INSULATION, 3000 V, 
or; 

-     for REINFORCED INSULATION, 6000 V. 

TIW not used. 

N/A