Read Harman Kardon DVD 23 (serv.man12) EMC - CB Certificate online
Report No. JSH05110331-001
Page 51 of 64
Floor standing EUT
The EUT was put on a 0.1m high wooder support, standing on the ground reference
plane(GRP) 2.6m by 1.8m, made by aluminuim 0.5mm thick.
A vertical coupling plane (VCP) 0.5m by 0.5m in size, the same material type and thickness as that
of the ground reference plane was applied ,and was connected to the GRP via a 470k
plane(GRP) 2.6m by 1.8m, made by aluminuim 0.5mm thick.
A vertical coupling plane (VCP) 0.5m by 0.5m in size, the same material type and thickness as that
of the ground reference plane was applied ,and was connected to the GRP via a 470k
Ω resistor at
each end.
The distance between EUT and any of the other metallic surface excepted the GRP, HCP & VCP
was greater than 1m.
The EUT was arranged and connected according to its functional requirements.
The distance between EUT and any of the other metallic surface excepted the GRP, HCP & VCP
was greater than 1m.
The EUT was arranged and connected according to its functional requirements.
14.3.2 Test Procedure
The EUT was arranged and connected according to its functional requirements
Direct static electricity discharges was applied only to those points and surface which are
Direct static electricity discharges was applied only to those points and surface which are
accessible to
personnel during normal usage.
The test voltage was increased from the minimum to the selected test level and with single
The test voltage was increased from the minimum to the selected test level and with single
discharge.
On each preselected points 10 times of each polarity single discharge were applied
The time interval between successive single discharges is 1s.
The ESD generator was held perpendicular to the surface to which the discharge is applied. The
discharge return cable of the generator was kept at a distance of 0.2m whilst the discharge is being
applied. During the contact discharges, the tip of the discharge electrode was touch the EUT before
the discharge switch is operated. During the air discharges, the round discharge tip of the discharge
electrode was approached as fast as possible to touch the EUT.
After each discharge, the ESD generator was removed from the EUT, the generator is then
The time interval between successive single discharges is 1s.
The ESD generator was held perpendicular to the surface to which the discharge is applied. The
discharge return cable of the generator was kept at a distance of 0.2m whilst the discharge is being
applied. During the contact discharges, the tip of the discharge electrode was touch the EUT before
the discharge switch is operated. During the air discharges, the round discharge tip of the discharge
electrode was approached as fast as possible to touch the EUT.
After each discharge, the ESD generator was removed from the EUT, the generator is then
retriggered for a new single discharge.
Indirect discharge was conducted to objects placed near the EUT, simulated by applying the
dischares of the ESD generator to a coupling plane, in the contact discharge mode.
10 times of each polarity single discharge were applied to HCP and VCP. The detail selected
points are listed in the following table.
Click on the first or last page to see other DVD 23 (serv.man12) service manuals if exist.