AVR 35 (serv.man4) - Harman Kardon Audio User Guide / Operation Manual. Page 35

Programming the Remote

33

Erasing All the Learned Commands For a
Single Device
To erase all the commands for a single
device, follow these steps:

1. Press the 

c

for the desired device (e.g., CD, TV,

VCR etc.) and the 

button 

j

at the

same time until the LED under the

turns red

and the 

a

turns and remains

orange.

2. Press and hold the 

button 

s

.

The 

a

will flash red five times, then the red

LED under the 

c

will turn off and the

a

will flash green twice, and then turn to a
steady orange color. The red LED under
the 

c

will turn back on.

3. Now release the 

button 

s

.

4. At this point, all the learned codes for the

device have been erased. To complete the
process, press and hold the 

c

and the 

button 

j

at the same time until the

a

flashes orange twice and then goes out,
and the red LED under the 

turns off.

Erasing All Learned Commands
To erase ALL commands that have been
learned to all buttons in the remote, follow
the instruction shown below. Note that this
will erase all commands for the CD, TAPE,
SAT, TV, VCR and CBL devices, but it will not
erase the commands for the AVR35RDS,
itself and all preprogrammed commands
for all devices.

To erase all learned commands, press and
hold the 

b

and the 

button 

s

at the

same time until the 

a 

flashes red

ten times, then green once and orange
once. When the 

a

stops flashing and turns

off, all learned commands have been
erased from the AVR35RDS remote control.

The AVR35RDS’s remote may be
programmed to operate the 

and 

button 

`

from

either the TV or the AVR to operate in
conjunction with any of the eight devices
controlled by the remote. For example,
since the AVR35RDS will likely be used as
the sound system for TV viewing, you may
wish to have the AVR’s volume activated
when the remote is set to run the TV. Either
the AVR or TV volume control may be
associated with any of the remote’s devices.

To program the remote for Volume Punch-
Through, follow these steps:

1. Press the 

c

for the device you wish to have

associated with the volume control
(e.g., TV, SAT, etc.) and the 

button 

`

at the same time until the

red light illuminates under the 

.

2. Press the 

button 

.

3. Press either the 

b

or the 

c

,

depending on which system’s volume
control you wish to have attached for
the punch-through mode. Note that the
red light under the 

will blink twice and then go

out to confirm the data entry.