AVR 35 (serv.man4) - Harman Kardon Audio User Guide / Operation Manual. Page 18

Installation and Connections

16

The AVR35RDS is designed for flexible use
with external control components and
power amplifiers. These connections are
easy to make during an initial installation,
or at a later date should you choose to
upgrade your system.

Remote Control Extension
If the receiver is placed behind a solid or
smoked glass cabinet door, the obstruction
may prevent the remote sensor from
receiving commands. In this event, an
optional remote sensor may be used.
Connect the output of the remote sensor to
the 

jack 

°

. 

If other components are also prevented
from receiving remote commands, only
one sensor is needed. They may use this
unit’s sensor or a remote eye by running a
connection from the 

jack 

·

to the Remote In jack on Harman

Kardon or other compatible equipment. 

AC Power Connections
This unit is equipped with two accessory
AC outlets. They may be used to power
accessory devices, but they should not be
used with high-current draw equipment
such as power amplifiers. The total power
draw may not exceed 50W to the switched
and 100W to the unswitched outlet.

The 

⁄

outlet will receive

power only when the unit is on. This is
recommended for devices that have no
power switch, or a mechanical power
switch that may be left in the “ON”
position.

NOTE: Devices with electronic power
switches may only go into a Standby mode
when plugged in here.

The 

¤

outlet will receive

power as long as the unit is on or in
Standby mode, but the power will be lost as
soon as the AVR35RDS is turned off
completely with the 

switch

1

.

Finally, when all connections are
complete, plug the power cord into a non-
switched 230-volt AC wall outlet. You’re
almost ready to enjoy the AVR35RDS!