Read Panasonic CS-VE9NKE / CS-VE12NKE / CU-VE9NKE / CU-VE12NKE Service Manual online
118
16.2.8.7 Fix-back Compressor and Connect the Tubes
1 Set compressor and heat charger block to the original position.
2 Tighten 2 mounting nuts of compressor by using wrench.
3 Braze-back the tubes you dismantled.
2 Tighten 2 mounting nuts of compressor by using wrench.
3 Braze-back the tubes you dismantled.
Caution
Protection from the brazing flame should be considered during brazing-back the parts, too.
4 After brazing tubes, use cooling rag (wet towel) to cool it down and put the materials such as butyl tape and
etc., as original conditions.
5 Reinstall the heat charger sensor to its original position and affix polyethylene sheet.
16.2.8.8 Assemble
Electrical Parts
1 Put back electrical parts to their original position.
2 Install soundproof material around compressor and secure soundproof board.
3 Secure heat charger and soundproof board using resin band. This is to prevent compressor and heat charger
2 Install soundproof material around compressor and secure soundproof board.
3 Secure heat charger and soundproof board using resin band. This is to prevent compressor and heat charger
from falling. There is no need to fasten tightly.
4 Put back each coil and sensor to their original position.
16.2.8.9 Setting Exterior Parts
1 Set and attach side panel (right) by using screws.
2 Set control board and insert each connector.
2 Set control board and insert each connector.
16.2.8.10 Vacuuming, Filling Refrigerant and Checking for Gas Leaks
1 Return outdoor equipment to where it was. Vacuum, fill coolant and check for gas leaks then test.
Click on the first or last page to see other CS-VE9NKE / CS-VE12NKE / CU-VE9NKE / CU-VE12NKE service manuals if exist.