Read Panasonic CS-VE9NKE / CS-VE12NKE / CU-VE9NKE / CU-VE12NKE Service Manual online
116
16.2.8.3 Process 2 (Removing Brazing Point)
1 Removing butyl tape from piping prior to removing the brazing point.
Caution
Protection from the brazing flame should be considered during replacing the parts.
Firstly disconnect the pipe which entering to heat charger, discharging from heat charger, compressor
suction and the discharging pipes.
Protection from the brazing flame should be considered during replacing the parts.
Firstly disconnect the pipe which entering to heat charger, discharging from heat charger, compressor
suction and the discharging pipes.
16.2.8.4 Separate Compressor from Heat Charger.
1 Take out blocks of compressor and heat charger from the base pan.
2 Cut off 2 bands (top and bottom) which holding compressor and heat charger, and lift the bracket to remove.
3 Remove the heat transferring sheet from the compressor once separate the heat charger from compressor.
4 Remove the sensor on heat charger by peeling off polyethylene sheet. Keep the sensor for re-use after the
2 Cut off 2 bands (top and bottom) which holding compressor and heat charger, and lift the bracket to remove.
3 Remove the heat transferring sheet from the compressor once separate the heat charger from compressor.
4 Remove the sensor on heat charger by peeling off polyethylene sheet. Keep the sensor for re-use after the
brazing work.
Click on the first or last page to see other CS-VE9NKE / CS-VE12NKE / CU-VE9NKE / CU-VE12NKE service manuals if exist.