Read JBL PULSE (serv.man6) EMC - CB Certificate online
- Page 6 of 9 -
www.nemko.com
Report No. 241619
Annex E
Last section of Annex E amended as: For
comparison of winding temperatures
determined by the resistance method of
this annexwith the temperature limits of
Table 4B, 35 °C shall be added to the
calculated temperaturerise. And add note:
for equipment not to be operated at tropical
climatic conditions, 25 °C shall be added to
the calculated temperature rise to compare
with the temperature of Table 4B.
comparison of winding temperatures
determined by the resistance method of
this annexwith the temperature limits of
Table 4B, 35 °C shall be added to the
calculated temperaturerise. And add note:
for equipment not to be operated at tropical
climatic conditions, 25 °C shall be added to
the calculated temperature rise to compare
with the temperature of Table 4B.
Thermocouple measurement
method
method
N/A
Annex
G.6
G.6
Change the second section of Clause G.6
to be: For equipment to be operated at
2000 m - 5000m above sea level, the
minimum CLEARANCE shall be multiplied
by the factor 1.48 corresponding altitude of
5000m given in Table A.2 of GB/T16935.1.
For equipment to be operated at more than
5000 m above sea level, the minimum
CLEARANCE shall be multiplied by the
factor given in Table A.2 of IEC 60664-1.
Linear interpolation is permitted between
the nearest two points in Table A.2. The
calculated minimum CLEARANCE using
this multiplication factor shall be rounded
up to the next higher 0,1 mm increment.
to be: For equipment to be operated at
2000 m - 5000m above sea level, the
minimum CLEARANCE shall be multiplied
by the factor 1.48 corresponding altitude of
5000m given in Table A.2 of GB/T16935.1.
For equipment to be operated at more than
5000 m above sea level, the minimum
CLEARANCE shall be multiplied by the
factor given in Table A.2 of IEC 60664-1.
Linear interpolation is permitted between
the nearest two points in Table A.2. The
calculated minimum CLEARANCE using
this multiplication factor shall be rounded
up to the next higher 0,1 mm increment.
Must be considered when
market to China.
market to China.
Annex
BB
(informa
tive)
BB
(informa
tive)
Amended as :
The differences between Chinese national
standards GB 4943.1-2011 and GB 4943-
2001.
The differences between Chinese national
standards GB 4943.1-2011 and GB 4943-
2001.
Considered.
P
Click on the first or last page to see other PULSE (serv.man6) service manuals if exist.