Read Sony JMECHA Service Manual online
— 15 —
3-4. Brake-T Block Assy, T-reel Table Assy, Gooseneck Gear Assy
1.
Removal procedure
1)
Remove the brake-T block assy from the brake-T pivot shaft.
2)
While pressing the reel claw retainer A of the T-reel table assy
down in the direction of B, remove the reel claw C.
down in the direction of B, remove the reel claw C.
3)
Remove the gooseneck assy from the relay gear shaft.
Note:
Be careful not to break the reel claw.
2.
Attachment procedure
1)
Insert the gooseneck gear assy into the center hole of the relay
gear shaft. Bend the gooseneck gear assy to the S-reel table
assy side.
gear shaft. Bend the gooseneck gear assy to the S-reel table
assy side.
2)
Attach the brake-T block assy to the brake-T pivot shaft D.
3)
Move the brake-T counter-clockwise so that T-brake is freed.
While pressing down the reel claw of the T-reel assy, fix the T-
reel to the reel shaft-T by rotating the reel.
While pressing down the reel claw of the T-reel assy, fix the T-
reel to the reel shaft-T by rotating the reel.
4)
Check that the brake spring-T works correctly by rotating the
T-reel table assy 30 degrees in the clockwise and counter-
clockwise directions.
T-reel table assy 30 degrees in the clockwise and counter-
clockwise directions.
Note:
The retainer on top of the brake spring-T must be hooked on the
brake-T pivot shaft D and moved down to the groove.
brake-T pivot shaft D and moved down to the groove.
Fig. 3-4
B
C
A
Gooseneck gear assy
T-reel table assy
Gooseneck gear assy
Relay gear shaft
Relay gear shaft
Brake-T block assy
Brake-T
Brake gear-T
Move the brake-T counter-clockwise
so that the T-brake is freed.
so that the T-brake is freed.
D
Brake-T pivot shaft
Brake-T block assy
Brake spring-T
T-reel table assy
S-reel table assy
E
Reel shaft-T
D
Brake-T pivot shaft
When attaching it,
bend the gooseneck gear
assy to the S-reel table
assy side.
bend the gooseneck gear
assy to the S-reel table
assy side.
Move the brake-T
counter-clockwise so that
the T-brake is freed.
counter-clockwise so that
the T-brake is freed.
Brake gear-T must be positioned so that
its steps face downward.
its steps face downward.
Click on the first or last page to see other JMECHA service manuals if exist.