Read Sony KV-SR253M53 Service Manual online
– 11 –
KV-SR253M53
RM-GA002
2-7 Insertion of Lead Assy, H
Insert Lead Assy, H static into CRT socket and
RV750 as shown.
Make sure the wire is naturally curved, to avoid
touching CRT neck.
RV750 as shown.
Make sure the wire is naturally curved, to avoid
touching CRT neck.
Note: Dress while chassis is halfway docked into beznet.
2-9 CV board Connector Assy wire dressing
1) Dress Conn Assy, 6P and Conn Assy, 4P VM using tie, cable at alignment hole 'B' on CV board as shown.
2) Dress Conn Assy, 4P 200V; Conn Assy, 6P; Conn Assy, 4P VM; Lead Assy, G2
and Lead Assy, Focus with purse lock
∅ 9.
2-8 Dress Lead Assy, Earth and Conn Assy,
5P Front In with purse lock
5P Front In with purse lock
∅ 9
Lead Assy, Earth
Make a 'S' shaped loop on Conn
Assy, 5P Front In and dress together
with Lead Assy, Earth using purse
lock
∅ 9.
Conn Assy, 5P Front In
Lead Assy, Earth
CAUTION:
Purse lock
∅
9
CN8108-CN606&607
CN8206-CN2103
CN8203-CN2102
Tie, cable at alignment hole
CAUTION:
Prevent tie, cable from touching rear
cover or any enclosures by turning
them away from it --> avoid rattle
sound. Also prevent tie, cable's end
from touching solder side of board.
Prevent tie, cable from touching rear
cover or any enclosures by turning
them away from it --> avoid rattle
sound. Also prevent tie, cable's end
from touching solder side of board.
Lead Assy, H
Static
RV750
CRT
socket
CRT neck
Prevent tie, cable from touching rear cover or any enclosures by
turning them away from it --> avoid rattle sound. Also prevent tie,
cable's end from touching solder side of board.
turning them away from it --> avoid rattle sound. Also prevent tie,
cable's end from touching solder side of board.
Click on the first or last page to see other KV-SR253M53 service manuals if exist.