Read Sony KV-LS212M50 Service Manual online
– 8 –
KV-LS212M50/M61/M81/N60
RM-GA002
2-3. Connector Assy, 5P (YUV wire) dressing
2-4. Connector dressing on A PWB
CAUTION :
1) Dress Lead Assy, Jumper according to the green route.
1) Dress Lead Assy, Jumper according to the green route.
=> Ensure Lead Assy, Jumper is dress away from shield case in the boxed area.
=> Ensure Lead Assy, Jumper is dress below Conn Assy, 5P (YUV).
Make sure the Connector Assy,
5P is kept close to board surface.
Make sure the UL tape is positioned
at the sharp edge of shield case to
prevent wire from being scratched
R121
Lead Assy, Jumper
Keep Lead Assy, Jumper away from
shield case --> C/M for OSD drift from
RF to Video mode
Connector Assy, 5P & Lead Assy,
Jumper go around shield case &
dress with pin wire A021
Conn Assy, 5P (YUV)
Lead Assy, Focus
Make sure rubber cap is pushed
down to make sure it covers
the FBT flange completely
FBT Flange
FBT Flange
AC Cord Holder
540 ± 5 mm
RY600
Dress AC Power Cord and Lead
Assy, Speaker (WHT+BLK) with
Pin, Wire A016
Assy, Speaker (WHT+BLK) with
Pin, Wire A016
Keep wires above of RY600
---> to avoid wires from being
sandwiched with front jack and
pushed against relay
---> to avoid wires from being
sandwiched with front jack and
pushed against relay
Pull wires towards right to prevent slacking, then
dress wires above capacitors' height as shown
--> prevent from touching high temperature parts
dress wires above capacitors' height as shown
--> prevent from touching high temperature parts
Dress AC Power Cord with Standing
Purse Lock, followed by Lead Assy,
Earth & Lead Assy, Speaker
(RED+BLK).
Purse Lock, followed by Lead Assy,
Earth & Lead Assy, Speaker
(RED+BLK).
Pull towards right
Lead Assy,
Speaker (RED+BLK)
AC Power Cord
Lead Assy, Earth
Standing Purse
Lock
2-5. AC Power Cord, Lead Assy, Speaker and Lead Assy, Earth dressing at A board
Make sure Conn Assy, 5P
does not touch resistor, R121
does not touch resistor, R121
HV Cap Assy
Lead Assy, G2
Click on the first or last page to see other KV-LS212M50 service manuals if exist.