KV-HG21M60 - Sony TV Service Manual (repair manual). Page 9

– 8 –

 

R121

 

 

)

OK

NG

Dress Conn Assy, 7P (RGB) with
Cable Tie at alignment hole, A as shown.

Make sure Conn Assy, 7P (RGB)
does not direct contact with heat
sink of IC751

Conn Assy, 7P
(RGB)

Lead Assy, Focus

FBT Flange

Make sure Conn Assy, 5P
does not touch resistor, R121

Lead Assy, Jumper

Conn Assy, 5P (YUV)

Pin, Wire A021

Figure 5

Figure 5(a)

Figure 5(b)

Shield case

Shield case

Make sure the Connector Assy, 5P
(YUV) is press down towards the
board

1) Dress Conn Assy, 5P (YUV) & Lead Assy, Jumper with Pin, Wire A021 as shown.
2) Dress Lead Assy, Jumper according to the route shown in the Figure..
Note : Ensure Lead Assy, Jumper is dress away from shield case in the boxed area in Figure 5.
 

Ensure Lead Assy, Jumper is dress below Conn Assy, 5P (YUV).

Make sure rubber cap is pushed
down to make sure it covers
the FBT flange completely

Cable Tie, A

CAUTION:
Prevent tie, cable from touching
rear cover or any enclosures by
turning them away from it
--> avoid rattle sound. Also
prevent tie, cable's end from
touching solder side of board.

HV Cap Assy

FBT Flange

TVSR Requirement :
All Connectors must be kept away from FBT area by a minimum distance of
10mm

Make sure the UL tape is positioned
at the sharp edge of shield case to
prevent wire from being scratched

Conn Assy, 5P (YUV)

Lead Assy,

CAUTION:
1) Dress Lead Assy, Jumper according to the route shown
in the Figure 5.
=> Ensure Lead Assy, Jumper is dress away from shield
case in the boxed area.
=> Ensure Lead Assy, Jumper is dress below Conn Assy,
5P (YUV).