Read Sony KV-28FX66B Service Manual online
- 11 -
24
Specifications
Additional Information
Design and specifications are subject to change without notice.
100% Recycled Paper - Totally Chlorine Free
(SMARTLINK)
Sony Manufacturing Co, UK, hereby declares that this Colour TV is in compliance with the
essential requirements and other relevant provisions of Directive 1999/5/EC.
essential requirements and other relevant provisions of Directive 1999/5/EC.
TV system:
I
I
Colour system:
PAL
SECAM, NTSC 3.58, 4.43 (only
Video In)
PAL
SECAM, NTSC 3.58, 4.43 (only
Video In)
Channel Coverage:
I: UHF B21-B69
I: UHF B21-B69
Picture Tube:
Flat Display FD Trinitron
WIDE: 28” (approx. 71 cm.
measured diagonally)
Flat Display FD Trinitron
WIDE: 28” (approx. 71 cm.
measured diagonally)
Rear Terminals
1
/
1
21-pin scart
connector
(CENELEC standard)
including audio/video
input, RGB input, TV
audio/video output.
audio/video output.
2
/
2
21-pin Scart
connector
(CENELEC standard)
including audio / video
input, RGB input, monitor
audio/video output.
audio/video output.
3
/
3
21-pin Scart
connector
(CENELEC
standard) including
audio / video input, S video
input, selectable
audio / video output and
Smartlink interface.
audio / video input, S video
input, selectable
audio / video output and
Smartlink interface.
audio outputs (Left/
Right) - phono jacks
Right) - phono jacks
Side Terminals
4
S Video input – 4 pin
DIN
DIN
4
video input – phono
jack
4
audio input – phono
jacks
headphones jack
Sound Output:
2 x 20 W (music power)
2 x 10 W (RMS)
2 x 10 W (RMS)
Woofer:
30 W (music power)
15 W (RMS)
30 W (music power)
15 W (RMS)
Power Consumption:
125 W
125 W
Standby Power
Consumption:
0.3 W
Consumption:
0.3 W
Dimensions (w x h x d) :
approx. 797 x 519 x 523 mm.
approx. 797 x 519 x 523 mm.
Weight:
approx. 49 Kg.
approx. 49 Kg.
Remote Control Locator
coverage:
up to 10 m. in open field
coverage:
up to 10 m. in open field
The optimum distance is
up to approximately 10
meters without interference.
However, the distance may
vary according to the
surroundings and
environment.
However, the distance may
vary according to the
surroundings and
environment.
Even within the signal
reception area, there are
some spots (dead spot) where
the RF signal can not be
received. This characteristics is
inherent to RF signals, and
does not indicate malfunction.
the RF signal can not be
received. This characteristics is
inherent to RF signals, and
does not indicate malfunction.
Remote Control Locator
Frequency:
434 MHz (ISM band).
Frequency:
434 MHz (ISM band).
The frequency of your
Remote Control Locator
may be used by other devices
(e.g. electric garage door). If
the use of the Remote Control
Locator causes interferences
with any other device(s) please
contact your nearest Sony
Service Centre.
(e.g. electric garage door). If
the use of the Remote Control
Locator causes interferences
with any other device(s) please
contact your nearest Sony
Service Centre.
Accessories supplied:
1 Remote Control (RM-937)
3 Batteries (IEC designated,
1 Remote Control (RM-937)
3 Batteries (IEC designated,
AA size)
Other features:
• 100 Hz picture, Digital Plus.
• Teletext, Fastext, TOPtext
• 100 Hz picture, Digital Plus.
• Teletext, Fastext, TOPtext
(250 page TEXT memory).
• Sleep Timer.
• Smartlink (direct link
• Smartlink (direct link
between your TV set and a
compatible VCR. For more
information on Smartlink,
please refer to the Instruction
Manual of your VCR).
compatible VCR. For more
information on Smartlink,
please refer to the Instruction
Manual of your VCR).
• Dolby Virtual.
• BBE.
• PIP.
• Auto Format.
• ACI (Auto Channel
Installation).
• Remote Control Locator.
•
• BBE.
• PIP.
• Auto Format.
• ACI (Auto Channel
Installation).
• Remote Control Locator.
•
Halogen free flame
retardant used in
cabinets.
S
S
25
GB
Troubleshooting
Here are some simple solutions to problems which may affect the picture and sound.
Additional Information
If you continue to experience problems, have your TV serviced by qualified personnel.
Never open the casing yourself.
Problem
No picture (screen is dark) and
no sound.
Poor or no picture (screen is
dark), but good sound.
No picture or no menu
information from equipment
connected to the Scart
connector.
Good picture, no sound.
No colour on colour
programmes.
Distorted picture when
changing programmes or
selecting teletext.
Distorted picture when pressing
the Remote Control Locator
button.
Picture slanted
Noisy picture when viewing a
TV channel.
• The remote control beeps even
you have not pressed the
remote control locator button
or on the contrary,
• When you press the remote
control locator button, the
remote control does not beep.
Remote control does not
function.
The standby indicator
on the
TV flashes.
Solution
• Check the aerial connection.
• Plug the TV in and press the
button on the front of the TV.
• If the standby indicator
is on, press TV
button on
the remote control.
• Using the menu system, select the “Picture Adjustment” menu and
select “Reset” to return to the factory settings.
• Check that the optional equipment is on and press the
button repeatedly on the remote control until the
correct input symbol is displayed on the screen.
• Press the
+ button on the remote control.
• Check that “TV Speakers” is “On” in the “Sound Adjustment”
menu.
• Check that headphones are not connected.
• Using the menu system, select the “Picture Adjustment” menu and
select “Reset” to return to factory settings.
• Turn off any equipment connected to the Scart connector on the rear
of the TV.
• This is not a malfunction. It could be caused because some broadcast
TV uses the same or close frequency as the remote control locator.
This problem will disappear when you stop pressing the button.
• Using the menu system, select the “Picture Rotation” option in the
“Detail Set Up” menu to correct the picture slant.
• Using the menu system, select the “Manual Programme Preset”
menu and adjust Fine Tuning (AFT) to obtain better picture
reception.
• Using the menu system, select the “Noise Reduction” option in the
“Picture Adjustment” menu and select “Auto” to reduce the noise
in the picture.
• Using the menu system, asign an ID (number) to your remote
control. (See “Remote Control ID” on page 17).
• Replace the batteries of the remote control and asign again an ID
(number) to your remote control. (See “Remote Control ID” on page
17).
• Check that the Media Selector on the remote control is set to the
device you are using (VCR, TV or DVD).
• If the remote control does not operate the VCR or DVD even when
the Media Selector has been set correctly. Enter the necessary code
set as explained on “Remote Control Configuration for VCR/DVD”
chapter of this instruction manual.
• Replace the batteries.
• Contact your nearest Sony service centre.
Click on the first or last page to see other KV-28FX66B service manuals if exist.