KV-28DS60U - Sony TV Service Manual (repair manual). Page 10

10

Press to mute TV sound. Press again to
restore the sound.

Press numbered buttons to select channels.

For double-digit programme numbers, e.g. 23,

press  -/-- first, then the buttons 2 and 3.

If you enter an incorrect first digit, this should

be corrected by entering another digit (0 - 9)

and then selecting -/-- button again to enter
the programme number of your choice.

Press to change the sound settings.

Press again to remove the display.

Press to adjust the volume of the TV.

Press to temporarily switch off TV.  Press again

to switch on TV from standby mode.

completely when TV is not in use.
NOTE: After 15 -30 minutes without a TV signal

and without any button being pressed, the TV
switches automatically into standby mode.

Press to reveal all on-screen indications.

Press again to cancel.

Press to select channels.

Press to change the size of the screen.

Press to change the picture settings.
Press again to remove the display.

Press to display the Event Schedule Guide.
Press again to remove display.

Press to select Teletext mode.

Press to return to the normal operation

from teletext mode or standby mode.

Press to temporarily switch off VCR (if Sony VCR connected).

Press again to switch on VCR.

Press to return to the previous channel you were

watching.  Note:  This can be done only after

watching the present channel for 5 seconds.

Use this OK button to select options

available in the menu system of the TV.

Open the remote control lid and
press to display the time on screen.

Open the remote control lid and press these

buttons to operate your video equipment
(please refer to your VCR manual).

With this selector you can control other Sony

equipment.  Open the remote control lid and

set the selector according to the type of

equipment you want to control then use the

buttons on the remote control to operate the

equipment:

VTR1 : Sony Beta VCR

VTR2 : Sony 8mm VCR

VTR3 : Sony VHS VCR

VTR4 : Sony Digital VCR

MDP : Sony Multi Disc Player

Open the remote control lid and

press to return picture and
sound levels to factory settings.

Press to freeze the picture.

Press again to cancel freeze.

Press to select inputs from the TV sockets (see

Using Optional Equipment section).

In teletext mode, press to freeze the displayed

page. Press once again to cancel.

To Display the Menu
Press if you wish to use the TV menu system.  Press

again to remove the menu from the TV screen.

Press the MENU button on the remote control to display
the menu on the TV screen.

Move the OK button on the remote control DOWN to
select the 

 symbol on the menu screen then move

RIGHT to enter the `PRESET' menu.

Move the OK button DOWN to select “Programme
Setup” then move RIGHT to enter the `PROGRAMME
SETUP' menu.

Move the OK button RIGHT to highlight the brackets
then move repeatedly DOWN to select `Digital' if you
wish to view digital channels or `Analogue' if you wish
to view analogue channels.

Press the OK button to confirm your selection.

 You can now view the channels by pressing the
PROGR+/- or the numbered buttons on the
remote control.

 Press the OK button on the remote control to display the
programme table on the TV screen.

 Push the joystick UP or DOWN to select `Digital/
Analogue' then move RIGHT to enter your option.

Move the joystick UP or DOWN to select `Digital' if you
wish to view digital channels or `Analogue' if you wish
to view analogue channels.

You have the option to view either digital channels or analogue channels.