HDR-PJ50, HDR-PJ50E, HDR-PJ50V, HDR-PJ50VE, HDR-XR160, HDR-XR160E (serv.man2) - Sony Movie Service Manual (repair manual). Page 8

HDR-PJ50/PJ50E/PJ50V/PJ50VE/XR160/XR160E_L2

1-4

After a part of set was replaced or after the set was assembled, check the reception of GPS signal.

Bring your camcorder to an open area, and set the GPS to ON (

 appears on the LCD screen). Your camcorder starts trying to triangulate. When 

your camcorder triangulates successfully, it will record the location information at the time movies and photos were recorded. 

• The indicator changes according to the strength of GPS signal reception.

• It may take a while before the camcorder starts triangulating.

To return the display of the unit to “A message appears asking you to confirm whether you agree with the terms of the license agreement of the map
data,” make settings according to the instructions on the SERVICE tab in the Adjustment Manual.

If you import GPS Assist Data from your computer to your camcorder using the supplied software “PMB,” the time it takes the camcorder to acquire 
your location information can be shortened.
Connect the camcorder to a computer that is connected to the Internet. The GPS Assist Data will be updated automatically.

Do not factory check HDD (PJ50/PJ50E/PJ50V/PJ50VE) in which Map Data is installed.
The Map data is erased when the factory check is done.

This model is provided with a flash unit using LED Flash/Video light (C7210).
Therefore, the LED Flash/Video light (C7210) does not have high voltage part and does need to be discharged.

NOTE ON REPLACING PROJECTOR UNIT (PJ50/PJ50E/PJ50V/PJ50VE)

Refer to the following flowchart when repairing or inspecting the projector’s projection function.

If you have received an indication on the projector’s projection function from the customer, check defective part according to the following flow-
chart. 
When a defective part has been clarified, repair the projector according to the check result.

Note 1: The projector unit (copper plate in particular) becomes hot after it is used.
 

When replacing a part of the projector unit, wait until it is cooled down.

 

Wipe the lens gently with a soft cloth such as a cleaning cloth or glass cleaning cloth.

Note 2: Stubborn stains may be removed with a soft cloth such as a cleaning cloth or glass cleaning cloth lightly dampened with water.
 

Never use a solvent such as alcohol, benzene or thinner; acid, alkaline or abrasive detergent; or a chemical cleaning cloth, as they will damage the lens sur-
face.

Indicated defective

projector received

Measure brightness.

( 2)

Replace projector unit. ( 1)

Projector Data Input

Fixed value input
Enter the number on the label attached to the unit.

Serial number input
LD40

Syywwnnnnn

Enter the red part.

Yes

No

OK

OK

NG

NG

OK

NG

A

B

Indication on

brightness

Inspect projector

LED.

( 1)

1 Refer to the ADJUST tab of Adjust Manual.
2 Refer to the SERVICE tab of Adjust Manual.

Inspect projector

LED.

( 1)

END

(See page 1-5)

(See page 1-5)