Read Sony HDR-HC9 / HDR-HC9E (serv.man2) Service Manual online
1-7
ENGLISH
JAPANESE
ENGLISH
JAPANESE
HDR-HC9/HC9E_L2
1-7-3. E : 62 : 11 [Shift Lens Overheating (Pitch)] Occurred
Connect the adjustment remote commander (RM-95 or NEW LANC JIG) and perform the following process.
Order Page Address Data
Procedure
1
0
01
01
2
0
10
06
3
B
B2
01
Press PAUSE (Write) button.
(6B)
4
0
10
07
5
D
46
F0
Press PAUSE (Write) button.
(7D)
6
D
48
01
Press PAUSE (Write) button. (Note 1)
(7D)
7
D
48
00
Press PAUSE (Write) button.
(7D)
8
D
46
10
Press PAUSE (Write) button.
(7D)
9
D
48
01
Press PAUSE (Write) button. (Note 1)
(7D)
10
D
48
00
Press PAUSE (Write) button.
(7D)
11
0
10
06
12
B
B2
00
Press PAUSE (Write) button.
(6B)
13
0
10
00
14
0
01
00
15
Check if the shift lens moves while setting the order 5 to 10. If the shift lens does not move, replace the
lens block (Note 2). When the shift lens moved, proceed to the order 16.
lens block (Note 2). When the shift lens moved, proceed to the order 16.
16
While setting the order 5 to 10, measure with an oscilloscope the output voltage of R5721 in the periphery
of IC5703 on the LD-221 board to check the output voltage varies.
of IC5703 on the LD-221 board to check the output voltage varies.
17
If the output voltage does not vary, replace the lens block (Note 2). When the output voltage varied,
proceed to the order 18.
proceed to the order 18.
18
Turn the power OFF.
19
While measuring with an oscilloscope the output voltage of R5792 in the periphery of IC5703 on the
LD-221 board, turn the power ON to check that the output voltage immediately after the power on
change as shown in Fig. 2.
LD-221 board, turn the power ON to check that the output voltage immediately after the power on
change as shown in Fig. 2.
20
If the output voltage change as shown in Fig. 2, replace the lens block (Note 2). If it does not change as
shown in Fig. 2, inspect the camera control circuit (IC1801 of VC-500 board) periphery.
shown in Fig. 2, inspect the camera control circuit (IC1801 of VC-500 board) periphery.
Note 1: Finish this operation within 10 seconds. If it is likely to take more than 10 seconds, set page: D (7D), address: 48, data:
00, and then retry.
Note 2: When the lens block was replaced, execute the necessary adjustment items referring to Service Manual, ADJ.
After the adjustment, make sure with the STEADYSHOT turned ON that the steadyshot functions appropriately in the
handheld operation.
handheld operation.
Click on the first or last page to see other HDR-HC9 / HDR-HC9E (serv.man2) service manuals if exist.