Read Sony HDR-HC9 / HDR-HC9E (serv.man2) Service Manual online
1-5
ENGLISH
JAPANESE
ENGLISH
JAPANESE
HDR-HC9/HC9E_L2
1-7. METHOD OF COPING WITH SHIFT LENS ERROR
about 330 msec
Fig. 1
Measurement points on the LD-221 board
IC5703
R5737
R5792
R5721
LD-221 BOARD (SIDE A)
Fig. 2
Change in output voltage of R5792 on the LD-221 board
Note: The length of low section will vary a little depending on the
conditions.
1-7-1. E : 62 : 02 [Abnormality of IC for Steadyshot] Occurred
Order
Procedure
1
Turn the power OFF.
2
While measuring with an oscilloscope the output voltage of R5792 in the periphery of IC5703 on the LD-221 board, turn the
power ON to check that the output voltage immediately after the power on change as shown in Fig. 2.
power ON to check that the output voltage immediately after the power on change as shown in Fig. 2.
3
If the output voltage change as shown in Fig. 2, replace the lens block (Note). If it does not change as shown in Fig. 2, inspect
the camera control circuit (IC1801 of VC-500 board) periphery.
the camera control circuit (IC1801 of VC-500 board) periphery.
Note: When the lens block was replaced, execute a necessary adjustment items referring to Service Manual, ADJ.
After the adjustment, make sure with the STEADYSHOT turned ON that the steadyshot functions appropriately in the
handheld operation.
handheld operation.
IC1801
R1823
IC1801
R1823
VC-500 BOARD (SIDE A)
Fig. 3
Measurement points on the VC-500 board
Click on the first or last page to see other HDR-HC9 / HDR-HC9E (serv.man2) service manuals if exist.