Read Sony HDR-CX630V / HDR-PJ630V / HDR-PJ650E / HDR-PJ650V / HDR-PJ650VE / HDR-PJ660 / HDR-PJ660E / HDR-PJ660V / HDR-PJ660VE (serv.man2) Service Manual online
1-7
HDR-CX630V/PJ630V/PJ650E/PJ650V/PJ650VE/PJ660/PJ660E/PJ660V/PJ660VE_L2
– ENGLISH –
Projector problem checking procedure (indication on brightness)
Yes
No
OK
NG
OK
NG
OK
NG
A
B
Indicated defective
projector received
Measure brightness.
( 2)
Measure brightness.
( 2)
Indication on
brightness
Inspect projector
LED.
( 1)
1 Refer to the ADJUST tab of Adjust Manual.
2 Refer to the SERVICE tab of Adjust Manual.
2 Refer to the SERVICE tab of Adjust Manual.
END
-
-
-
-
-
-
-
Replace projector unit (light emitting block). (*1)
Replace PJ board. (*1)
Replace both projector unit (light emitting block)
and PJ board. (*1)
Replace PJ board. (*1)
Replace both projector unit (light emitting block)
and PJ board. (*1)
Projector Data Input
Fixed value input
Enter the number on the label attached to the unit.
Serial number input
LD40
Enter the number on the label attached to the unit.
Serial number input
LD40
Syywwnnnnn
Enter the red part.
1-10 . LENS DEVICE (LSV-1400B) REPLACING METHOD
Lens Cap
A protective Lens Cap is attached to each new
service Lens Block.
Carry out replacement work with this Lens Cap
attached.
service Lens Block.
Carry out replacement work with this Lens Cap
attached.
Note:
Removal
(1) Remove the five screws.
TOP
FRONT
Screw
Screw
Screw
Screw
Screw
(2) Remove the four screws.
TO
P
FRONT
Screw
Screw
Screw
Screw
(3) Disconnect the connector and peel off the adhesive part of the LF-
2025 Flexible Board.
TO
P
FRO
NT
Adhesive part
Connector
LF-2025 Flexible Board
(4) Peel off the adhesive part of the LF-2026 Flexible Board.
TO
P
FRONT
Adhesive part
LF-2026 Flexible Board
Click on the first or last page to see other HDR-CX630V / HDR-PJ630V / HDR-PJ650E / HDR-PJ650V / HDR-PJ650VE / HDR-PJ660 / HDR-PJ660E / HDR-PJ660V / HDR-PJ660VE (serv.man2) service manuals if exist.