DCR-TRV940, DCR-TRV940E, DCR-TRV950, DCR-TRV950E (serv.man4) - Sony Movie Service Manual (repair manual). Page 8

6-5

For details of how remove the cabinet and boards, refer
to “2. DISASSEMBLY”.

When performing only the adjustments, the lens block
and boards need not be disassembled.

Before perform the adjustment, check that the data of
page: 0, address: 10 is “00”.
If not, select page: 0, address: 10, and set data “00”.
1) Connect the equipment for adjustments according to

Fig. 6-1-3.

As removing the cabinet (R) (removing the CK-116 board
CN5203) means removing the lithium 3V power supply
(BT5201), data such as date, time, user-set menus will
be lost. After completing adjustments, reset these data.
If the NS-014 board has been removed, the self-diagno-
sis data, data on history of use (total drum rotation time,
etc. ) will not be lost. (Refer to “SELF-DIAGNOSIS
FUNCTION” for the self-diagnosis data, and to “6-4.
Service Mode” for the data on the history use)

Setting the “Forced Camera Power ON” Mode
1) Select page: 0, address: 01, and set data: 01.
2) Select page: D, address: 10, set data: 01, and press

the PAUSE button of the adjustment remote com-
mander.
The above procedure will enable the camera power
to be turned on with the power switch (PS-1870 block)
removed. After completing adjustments, be sure to
exit the “Forced Camera Power ON Mode”.

Exiting the “Forced Camera Power ON” Mode
1) Select page: 0, address: 01, and set data: 01.
2) Select page: D, address: 10, set data: 00, and press

the PAUSE button of the adjustment remote com-
mander.

3) Select page: 0, address: 01, and set data: 00.

Pattern box

Front of the lens

1m