CPD-M151 - Sony Monitor Service Manual (repair manual). Page 6

1-2

6

Before using this monitor, check that the following items are
included in your carton:
• LCD monitor (1)
• Rear cover (1)
• Power cord (1)
• AC adapter (1)
• HD15 video signal cable (1)
• Macintosh adapter (1)
• Rubber pads (2)
• Windows

 

 Monitor Information Disk/Utility Disk (1)

• Macintosh Utility Disk (1)
• Warranty card (1)
• These operating instructions (1)

You can set up the monitor on its stand or use it without the
stand.  The procedure of connecting cables and attaching the
rear cover differs depending on how you set up the
monitor.  In either case, read:
Step 1: Connect the monitor to the computer
Step 2: Connect the power cord
to connect the monitor to the computer and power source.
The connection is explained using the stand-type set up for
the illustration; however, the connector to be connected and
adapter required are the same even when the stand is not
used.

Connect the video signal cable and power cord, then attach
the rear cover.

The tilt feature allows the
monitor to be adjusted
within 65

°

 upward. To

adjust the angle, hold at the
bottom with both hands as
illustrated.

°

First detach the stand, and then connect the video signal
cable and power cord.  Attach the rear cover.  The rear cover
becomes the stand.  See “Using the monitor without the
stand” on page 8.

The tilt feature allows the
monitorto be adjusted within
25

°

 upward. To adjust the

angle, hold at the bottom
and open the stand as
illustrated.

°

7

Use the supplied Macintosh adapter.

*

Connect the supplied Macintosh adapter to the computer before
connecting the cable. This adapter is compatible with Macintosh
LC, Performa, Quadra, Power Macintosh and Power Macintosh
G3 series computers (sold before January, 1999). If you are
connecting to a Power Macintosh G3 series that sold after
January 1999, you will need a different adapter (not supplied).
Macintosh II series and some older versions of PowerBook
models may need an adapter with micro switches (not
supplied).

With the monitor and computer switched off, connect one
end of the power cord to the AC power adapter, and the AC
power adaptor to the monitor.  Then connect the other end o
the power cord to a power outlet.

Turn off the monitor and computer before connecting.

This monitor uses the No. 9 pin in the video signal connector for
Plug & Play (DDC1 and DDC2B) compatibility.  See page 21 for the
location of the No. 9 pin.
• If your computer accepts the No. 9 pin, use the supplied HD15

video signal cable.

• If your computer does not accept the No. 9 pin, please consult

your dealer for advice on obtaining an HD15 adapter.