SAL70400G2 - Sony Digital Camera Service Manual (repair manual). Page 7

2-4

Note for assembling and grease applying positions are shown.

SAL70400G2 (4-5.6/70-400 G SSM Ⅱ) (70-400mm F4-5.6 G SSM Ⅱ)

Adhesive Bond (B-10): J-6082-612-A

1.  Apply the adhesive bond (B-10) 50  range wide to the surface against screwing position of the decoration barrel.

 

Decoration Barrel

50

50

Apply the adhesive 
bond (B-10)

2.  Tighten the decoration barrel as far it goes and turn back by one turn to align the positions of screw holes.

 

Tighten the 1st slip barrel so that the end surface of eye-piece side of decoration barrel mates flatly to the flat portion of 1st slip 
barrel.

3.  Tighten one screw.

 

5

1 Tighten as far as it goes.

3

Decoration Barrel

1st Slip Barrel

Decoration Barrel

2 Turn back by about one turn.

Align the positions
of screw holes.

Adjust so that the end surface of eye-piece side 
mates to the flat portion of 1st slip barrel.

End surface of 
eye-piece lens side

Flat portion

1.  Install the 1st lens assy to the unit, aligning the index mark with the character (inscription). Then, fix it with three screws.
2.  Install the decoration barrel to the unit, aligning the index mark with the character (inscription). Then, fix it with three screws.
3.  Install the filter screw frame to the unit, aligning the index mark of unit with the character (inscription) and the positions of hood click 

portion. Then, fix with three screws.

 

Decoration Barrel

Filter Screw Frame

1st Lens Assy

Filter Screw Frame
(Viewed from the objective lens side)

1st Lens Assy
(Viewed from the objective lens side)

Decoration Barrel
(Viewed from the objective lens side)

Index mark

Character 
(Inscription)

Character 
(Inscription)

Character 
(Inscription)

Unit

Hood click portion

(Back side)

Character 
(Inscription)

(Back side)

Character 
(Inscription)

Character (Inscription)

Hood click portion