Read Sony SAL2470Z2 Service Manual online
4-7
SAL2470Z2 (Vario-Sonnar 2.8/24-70 ZA SSM II) (Vario-Sonnar T* 24-70mm F2.8 ZA SSM II)
4-4. PROJECTIVE RESOLVING POWER CHECK/ADJUSTMENT
4-4-1. Projective Resolving Power Check
Equipment
• Lens Test Projector and Variable Transformer (Output voltage: AC 100 V)
• Lens Test Projector and Variable Transformer (Output voltage: AC 100 V)
Note:
Connect the variable transformer (Output voltage: AC 100 V) to the lens test projector.
• A-mount Attachment
• Screen (Art paper)
• Tape Measure
• Plane Mirror (For SLRs)
• Screen (Art paper)
• Tape Measure
• Plane Mirror (For SLRs)
1. Preparations
Note:
Note:
Check the projective resolving power of the checking lens at the following focal-length and distance.
Focal-length f (mm)
distance (m)
24
1.09
35
1.50
50
2.07
70
2.76
Table
4-4-1
1) Perform the following steps (1) to (3), and incorporate the internal lenses of the lens test projector according to the checking focal
length.
(1) Open the lid of the lens test projector.
(2) Pull up and turn the fixed levers on the right and left sides of the lens test projector.
(3) Remove or insert the lens.
(1) Open the lid of the lens test projector.
(2) Pull up and turn the fixed levers on the right and left sides of the lens test projector.
(3) Remove or insert the lens.
Note:
Be sure to have the right position and direction of the lens.
Lens test projector
Incorporate of the lenses
according to the checking focal-length (f).
according to the checking focal-length (f).
Lens
Fixed lever
Fixed lever
Lid
f=18 to 35 mm
f=35 to 100 mm
f=100 to 200 mm
f=200 to 300 mm
Heat-absorbing filter
Chart
Chart
Chart
Chart
Filament
Filament
Filament
Filament
Fig.
4-4-1
2) Attach the checking lens to the lens test projector, and set the equipment as shown in Fig.4-4-2.
Note:
When attach the checking lens to the lens test projector, remove the rear light shield barrel.
3) Turn the fan switch of the lens test projector to ON, then turn the lamp switch to ON.
Distance
Lens test projector
Chart
Fan switch
Lamp switch
Plane mirror
Screen
A-mount attachment
Checking lens
F
L
Fig.
4-4-2
4) Turn the focus ring of the checking lens until the chart image projected on the screen is the sharpest at the center (y =0).
5) Set the plane mirror to the center of the projected image (y = 0), and adjust the projector position so that the mirror reflects the light to
5) Set the plane mirror to the center of the projected image (y = 0), and adjust the projector position so that the mirror reflects the light to
the center of the lens.
2. Checking Method
1) Turn the focus ring of the checking lens until the chart image projected on the screen is the sharpest at the center (y =0).
2) Read the number of the smallest pitched lines at the center (y = 0).
1) Turn the focus ring of the checking lens until the chart image projected on the screen is the sharpest at the center (y =0).
2) Read the number of the smallest pitched lines at the center (y = 0).
The number represents for lines per mm.
Sagittal (S)
Meridional (M)
Fig.
4-4-3
Click on the first or last page to see other SAL2470Z2 service manuals if exist.