DSLR-A100, DSLR-A100H, DSLR-A100K, DSLR-A100W - Sony Digital Camera Service Manual (repair manual). Page 104

2008H0500-1

© 2008.8

(DI08-217)

DSLR-A100_L2

US Model

Canadian Model

AEP Model

UK Model

E Model

Australian Model

Hong Kong Model

Chinese Model

Korea Model

Japanese Model

Tourist Model

•

Repair (if the adjusting method failed)
1. Disassemble until the CCD Set can be removed.
2. Cut at two bosses for positional reference and directional reference of the CCD holder and the radiation plate. (Fig. 6-3)
3. Attach an insulation sheet to the terminal of CCD Set. (Prevention of short-circuit with CCD holder)
4. Assemble the CCD Set by shifting it by the amount of play

If an image tilts toward the lower right, shift clockwise the CCD Set by the amount of play.
If an image tilts toward the lower left, shift counterclockwise the CCD Set by the amount of play.
The double-sided adhesive tape on the LPF, if shifted by the amount of play, can be corrected in a range of about +/–0.7 degree
maximum.
In this case, however, prepare the service part "Slider Unit: A-1246-028-C" and modify it as described in step 2 above to make it
as a jig, and then shift the LPF on the jig (for prevention of damage to the Steadyshot Set of user's camera).

5. Assemble up to the exterior.
6. Check the tilt following the checking method.

*

If not within +/–0.5 degree, replace the "Slider Unit: A-1246-028-C" and recheck.

7. After the repair completed, perform "CCD Aori and Center Adjustment" and "Steadyshot Sensitivity Adjustment".

•

This SUPPLEMENT-3 is the revised version
of SUPPLEMENT-2.
Replace the SUPPLEMENT-2 (9-852-130-85)
with the SUPPLEMENT-3.
Please discard the  SUPPLEMENT-2.