Read Sony DSC-W730 (serv.man2) Service Manual online
DSC-W730_L2
1-7
1-8. ORNAMENTAL RING A REPLACING METHOD
Removal
1
1
Turn on the power switch and extend the lens (TELE end).
2
Detach the battery.
3
Apply alcohol to two gaps A of the Ornamental Ring A with tweezers or a fine-tipped stick as shown below.
4
Turn the Ornamental Ring A clockwise and counterclockwise to detach it.
Note: As for the figure below, this model and the shape of the main
body are different.
Note: 下図は当機種と本体の形状が異なります。
Ornamental Ring A
Solvent
A
Tweezers
5
Disengage the four claws and remove the Barrier Assy.
Barrier Assy
Claws
Claws
Installation
1
1
Fit the four claws while inserting the Barrier Lever into the hole and attach the Barrier Assy.
Barrier Assy
Claws
Claws
Hole
Barrier
Lever
2
Peel off the release papers of the Barrier Tapes.
3
Install the Ornamental Ring A and press it lightly.
Barrier Tapes
Barrier Assy
Barrier Tapes
Ornamental Ring A
1-9. DC MOTOR WORN ASSY REPLACING METHOD
Removal
1
1
Disengage the two claws and remove the FG Leaf Spring.
2
Remove the two Sensors.
3
Remove the three ribs and the boss, and then disconnect the connector.
4
Remove the boss.
Ribs
Rib
Boss
Boss
Flexible Board
Connector
Sensors
FG Leaf Spring
5
Remove the four screws and remove the Rear Mirror Plate .
6
Remove the Gear Worm Wheel, Gear A, and Gear B.
Gear A
Gear B
Gear Worm
Wheel
Screws
Screw
Rear Mirror
Plate
7
Remove the solder at two location to detach the DC Motor Worm Assy and remove the two screws.
Screws
Flexible Board
DC Motor Worm Assy
Solders
Click on the first or last page to see other DSC-W730 (serv.man2) service manuals if exist.