Read Sony DSC-W730 (serv.man2) Service Manual online
DSC-W730_L2
1-8
Installation
1
1
Install the DC Motor Worm Assy to the Stationary Tube Assy with two screws.
2
Solder the DC Worm Assy onto the Flexible Board at two locations.
Screws
Flexible Board
DC Motor Worm Assy
Stationary Tube Assy
Solders
3
Turn the Gear in the arrow direction to extend the lens barrel slightly.
4
Turn portion A in the arrow direction to TELE end and remove the Flexible Board from the hole in the Stationary Tube Assy.
5
Install the Gear Worm Wheel, Gear A, and Gear B.
Gear
A
Gear A
Gear B
Gear Worm
Wheel
Wheel
6
Install the Rear Mirror Plate.
7
Tighten the four screws in the order of numbers in the figure below.
8
Apply a voltage of 2.5 V to the DC Motor and retract the Lens.
Screws
Screw
Rear Mirror
Plate
Plate
2
4
3
1
9
Install Flexible Board to the boss.
0
Insert the Flexible Board into the connector and engage the Flexible Board with the three ribs and the boss.
qa
Install the two Sensors and attach the FG Leaf Spring.
Note: Attach the FG Leaf Spring in the correct orientation.
OK
NG
FG Leaf Spring
FG Leaf Spring
Flexible Board
Ribs
Rib
Boss
Boss
Connector
Sensors
FG Leaf Spring
Click on the first or last page to see other DSC-W730 (serv.man2) service manuals if exist.