DSC-W690 (serv.man2) - Sony Digital Camera Service Manual (repair manual). Page 6

DSC-W690_L2

1-4

Note: As for the figure below, this model and the shape

of the main body are different. 

Barrier Assy

Claws

Claws

Barrier Assy

Claws

Claws

Hole

Barrier

Lever

Ornamental Ring A

Barrier Tapes

Barrier Assy

Barrier Tapes

Ornamental Ring A

Disengage the four claws and remove the Barrier Assy.

Fit the four claws while inserting the Barrier Lever into the hole and attach the Barrier Assy.

Peel off the release papers of the Barrier Tapes.
Install the Ornamental Ring A and press it lightly.

Turn on the power switch and extend the lens (TELE end).
Detach the battery.
Apply alcohol to two gaps A of the Ornamental Ring A with tweezers or a fine-tipped stick as shown below.
Turn the Ornamental Ring A clockwise and counterclockwise to detach it.

Solvent

A

Tweezers

Claws

Sensors

FG Leaf

Spring

Claw

FPC Retainer

Z Retainer

Removal
1. Disengage the two claws and remove the FG Leaf Spring.
2. Remove the two Sensors.
3. Disengage the claw and remove the FPC Retainer.
4. Peel off the FPC Tape.
5. Disconnect the two Flexible Boards from the Connectors on the LF-139 Flexible Board.

6. Remove the LF-139 Flexible Board.
7. Remove the four screws and remove the Z Retainer and the Sensor.

8. Detach the Rear Mirror Plate and remove the Gear Worm Wheel, Gear A, and Gear B.

9. Remove the two screws and remove solder at two locations to detach the DC Motor Worm Assy.

Gear A

Gear B

Gear Worm

Wheel

Ribs

Rib

Rib

Rib

Boss

Boss

Screws

Screws

Screw

Sensor

Boss

Boss

Flexible Board

LF-139 Flexible Board

LF-139 Flexible Board

Flexible Board

FPC Tape

Connector

Connector

Rear Mirror

Plate

DC Motor Worm Assy

Solders