Read Sony DSC-TX5 (serv.man2) Service Manual online
DSC-TX5_L2
1-7
2. Remove the ML Lid Assy by sliding it with holding down the R Push Rod.
Note: Be careful that do not flick the R Push Rod.
3. Install the new ML Lid Assy to opposite procedure to removal.
1-6 REPLACING THE CABINET (REAR) ASSY
1-6-1. Service Tool
LCD-PUSHER: J-6082-732-A
1-6-2. Disassembly
1. Set the Cabinet (Rear) Assy on the LCD-pusher with aligning the each pin position.
2. Hold down the cabinet (rear) assy to LCD-pusher with holding tightly on the four corners.
Note: • Hold tightly on the four corners without holding the touch panel.
• Push it on vertically with no leaning.
If the load is applied at a point, LCD can be split.
3. Check that there is no abrasion on the seal portion (white portion of touch panel circumference).
Note: It may cause the water leak that there is abrasion on the seal portion.
4. Peel off the adhesive paper cleanly.
Note: • Do not touch the electricity-rubber.
• Do not left the adhesive material.
1-6-3. Assembly
1. Set the Cabinet (Rear) Assy on the LCD-pusher with aligning the each pin position.
– ENGLISH –
Click on the first or last page to see other DSC-TX5 (serv.man2) service manuals if exist.