DSC-T50 (serv.man4) - Sony Digital Camera Service Manual (repair manual). Page 27

6-25

DSC-T50_ADJ

11. CAMERA Adjustment 8
Perform this adjustment only when replacing the angular velocity
sensor or lens block. When the microprocessor, circuit etc. is dam-
aged, don't perform this adjustment but check the operations only.

Note down the sensitivity displayed on the angular velocity sensor of
the repair parts. At this time, note down also to which board it was
attached to.
Be sure to check because if attached incorrectly, the screen will vi-
brate up and down or left and right during the steady shot operations.

Precautions on the Parts Replacement
The PITCH sensor and the YAW sensor are different parts.

Precautions on Angular Velocity Sensor
The sensor incorporates a precision oscillator. Handle it with care as
if it dropped, the balance of oscillator will be disrupted and opera-
tions will not be performed properly.

Adjustment Page

CF

Adjustment Address

0C, 0D

Note: The sensor sensitivity of SE501 and SE502 of the SY-164

board is written only repair parts.

Preparation:
1) Read the PITCH sensor (SY-164 board SE501) sensitivity writ-

ten on repair parts, and named this as S

501

.

2) Read the YAW sensor (SY-164 board SE502) sensitivity writ-

ten on repair parts, and named this as S

502

.

SE501

SE502

SY-164 BOARD (SIDE B)

XX

XX

YAW sensor sensitivity

t

 S

502

PITCH sensor sensitivity t S

501

11-2. Preparation when the lens is replaced
Note down the PITCH/YAW data on the replacement lens for repair.

Adjustment Page

CF

Adjustment Address

0C, 0D

Note 1: The PITCH/YAW data of lens is written only repair parts.

Preparation:
1) Read the PITCH data written on repair parts, and named this

as L

1

.

2) Read the YAW data written on repair parts, and named this as

L

2

.

YAW data    t L

2

PITCH/YAW Data

PITCH data t L

1

X.XX / X.XX