View Sony DSC-T10 Service Manual online
mark 0 or dotted line with
mark 0 are critical for safety.
Replace only with part num-
marque 0 sont critiques pour la
Ne les remplacer que par une pièce
portant le numéro spécifié.
COMPONENTS WITH SONY PARTS WHOSE PART NUMBERS
APPEAR AS SHOWN IN THIS MANUAL OR IN SUPPLEMENTS
PUBLISHED BY SONY.
CRITIQUES POUR LA SÉCURITÉ DE FONCTIONNEMENT. NE
REMPLACER CES COMPOSANTS QUE PAR DES PIÈSES SONY
DONT LES NUMÉROS SONT DONNÉS DANS CE MANUEL OU
DANS LES SUPPÉMENTS PUBLIÉS PAR SONY.
connections. Check the entire board surface for solder splashes
"pinched" or contact high-wattage resistors.
transistors, that were installed during a previous repair. Point
them out to the customer and recommend their replacement.
of deterioration. Point them out to the customer and
recommend their replacement.
circuit board (within 3 times).
free mark (LF) indicating the solder contains no lead.
(Caution: Some printed circuit boards may not come printed with
the lead free mark due to their particular size.)
Ordinary soldering irons can be used but the iron tip has to be
applied to the solder joint for a slightly longer time.
Soldering irons using a temperature regulator should be set to
heated tip is applied for too long, so be careful!
Unleaded solder is more viscous (sticky, less prone to flow) than
ordinary solder so use caution not to let solder bridges occur such
as on IC pins, etc.
It is best to use only unleaded solder but unleaded solder may
also be added to ordinary solder.
Replace only with the same or equivalent type.
Memory (Internal Memory/Music) ································· 1-2
The message “All data in internal memory will be copied Ready?” appears.
possibly corrupting the data.
• The original images in the internal memory are retained even after copying. To delete the contents of the
• Even if you copy data, a
The message “All data in internal memory will be erased Ready?” appears.
The format is complete.
this happens, perform [Format Music].
When [Format Music] is performed, all the Music files are erased. Use the supplied software
“Music Transfer” to activate [Download Music].
The message “All data will be erased Ready?” appears.
All the Music files are erased.
(CCD SIGNAL PROCESS)
(LENS DRIVE, OIS DRIVE)
include the board name.
• All capacitors are in
Be careful not to heat the minus side of tantalum
capacitor, Because it is damaged by the heat.
In such cases, the unused circuits may be indicated.
color bar chart of pattern box. They are reference values
and reference waveforms.
(VOM of DC 10 M
(In addition to this, the necessary note is printed in each block)
Small pattern box
L = 11 cm (PTB-1450)
In addition, ensure that the receiver is not covered with
dusts nor exposed to strong light.
Ne les remplacer que par une pièce portant le numéro
so that there PRINTED WIRING BOARD
and SCHEMATIC DIAGRAM are omitted.